BOLT 5350604 - Caterpillar

Tighten bolts which fasten into front plate to ... 17 3 lb. ft.(23 4 N m)Six studs and nuts hold the cover for the fuel injection pump drive gear. Put 8H5137 Thread Sealant on the threads of the studs before installing them in the front housing.Tighten six nuts holding cover for fuel pump drive gear to ... 20 5 lb. ft.(25 7 N m)(1) With the timing bolt installed in the flywheel housing and the 8S5417 Timing Fixture Plate installed on the rear face of the accessory drive housing, tighten nut (1) to ... 103 10 lb. ft.(139 N m)(2) Camshaft gear.(3) End play for the idler gear (new) ... .004 to .016 in.(0.10 to 0.41 mm)Maximum permissible end play (worn) ... .034 in.(0.86 mm)Bore in bearing for the idler gear (new) ... 1.3781 .0019 in.(35.004 0.048 mm)Diameter of shaft for idler gear (new) ... 1.3741 .0005 in.(34.902 0.013 mm)Clearance between shaft and bearing (new) ... .0016 to .0064 in.(0.041 to 0.163 mm)Maximum permissible clearance between shaft and bearing (worn) ... .009 in.(0.23 mm)(4) Crankshaft gear.(5) Idler gear for oil pump.(6) Drive gear for oil pump.