BOLT 5437005 - Caterpillar

Illustration 4 g01200582
The "Modify Plane" menu option
Press the "Modify Plane" button. Alternatively, from the Files menu, select "Modify Plane".Note: You can only modify an Inclined Plane design if the inclined plane file is set as the "Prime" file.
Illustration 5 g01200590
The Plane Modification dialog
If a flat plane is required, then check the "Flat Plane" check box in order to disable the Slope button. If a slope is required, then clear the "Flat Plane" check box in order to enable the "Slope" button.
Position the machine at the desired origin of the inclined plane. Point the machine in the desired direction of the slope.
Press the "Set First Point" button. The "Northing" and "Easting" "Elevation" values in the "Origin" group are updated to the current position of the machine. The "Heading" value is updated with the current heading of the machine.
Enter a cross slope in order to define a slope that is perpendicular to the centerline of the inclined plane. A positive cross slope creates an inclined plane (as viewed from the machine's cab) with the left side higher than the right side.
Illustration 6 g01200561
Keypad
Use the keypad in order to enter the new slope. Press "OK".
Press the "Heading" button and use the keypad in order to adjust the direction of the slope.
Use the parameters from Table 1 in the "Lines" group in order to enter lines for guidance and then Press "OK".
Table 1
Field     Use    
Count     Enter the desired number of lines.    
Spacing     Enter the desired spacing between the lines.    
Length     Enter the desired length of the line.    Modifying an Inclined Plane: The Two Points Method
The "Two Points" method defines an inclined plane between two machine positions.
Illustration 7 g01200387
The two points method used in order to define an inclined plane
Modify Plane - Use the "Modify Plane" button in order to change an "Inclined plane". ReferenceFor more information about modifying files, refer to Operation and Maintenance, SEBU8277, "Selecting File for Window Display".Use the following steps in order to modify an Inclined Plane design using two points:
Select the "Inclined Plane" design file.
Press the "Modify Plane" button. Alternatively, from the "Files" menu, select "Modify Plane".Note: You can only modify an Inclined Plane design if the inclined plane file is set as the "Prime" file.
Illustration 8 g01200582
The "Modify Plane" menu option
Illustration 9 g01200590
The "Plane Modification" dialog
If a flat plane is required, then check the "Flat Plane" check box in order to disable the Slope button. If a slope is required, then clear the "Flat Plane" check box in order to enable the "Slope" button.
Position the machine at the desired origin of the plane.
Press the "Set First Point" button. The "Northing", "Easting" and "Elevation" values in the "Origin "group are updated to the current machine position. The "Heading" value is updated with the current machine heading.
In order to define a slope that is perpendicular to the centerline of the inclined plane, press "Cross Slope" in the "Origin" group. A positive cross slope creates an inclined plane so that the left side is higher than the right