BOLT 5F9338 - Caterpillar

Uninterruptible Power Supply: UPSB125 (S/N: SEP1-UP) UPSB130 (S/N: XTC1-UP)Introduction
This Special Instruction will guide you through the installation and the configuration of the Acquisition Card.Important Safety Information
Work safely. Most accidents that involve product operation, maintenance, and repair are caused by failure to observe basic safety rules or precautions. An accident can often be avoided by recognizing potentially hazardous situations before an accident occurs.A person must be alert to potential hazards. This person should also have the necessary training, skills, and tools in order to perform these functions properly.Safety precautions and warnings are provided in this instruction and on the product. If these hazard warnings are not heeded, bodily injury or death could occur to you or to other persons. Caterpillar cannot anticipate every possible circumstance that might involve a potential hazard. Therefore, the warnings in this publication and the warnings that are on the product are not all inclusive. If a tool, a procedure, a work method or operating technique that is not specifically recommended by Caterpillar is used, you must ensure that it is safe for you and for other people to use. You should ensure that the product will not be damaged or the product will be made unsafe by the operation, lubrication, maintenance or the repair procedures that are used.Contents
Illustration 1 g01995894
Optional equipmentThe optional equipment is made up of the following components:
one acquisition card
one DB9/DB9 RS232 serial communication cable
one installation and user manual for the acquisition card (this document)Storage
The acquisition card should be stored in the following conditions:
The card should remain in the original package.
The card should remain in a dry place.
The storage temperature range is −40° C (−40° F) to 70° C (158° F).Recycling of Packing Material
Packing materials must be disposed of in compliance with applicable laws and regulations.Function
The acquisition card is an optional part of the MulitSlot module.The acquisition card acts as the interface between the I2C bus of the MultiSlot module and the UPS.The acquisition card will use the proprietary protocol (U-Talk) for the UPS system or the basic protocol (dry contacts). The acquisition card that is connected to the UPS acquires measurements, status information and alarms. The acquisition card that is installed in the UPS transmits the data to the I2C bus of the MultiSlot module.Overall View
Illustration 2 g01996057
(1) jumpers and DIP switches for acquisition card settings (2) UPS U-Talk or Basic acquisition port (3) green light that is indicating the operation of the acquisition card (4) reset button (5) unused portNote: Jumpers JMP4, JMP5, and JMP6 are not used for this application.Settings for the Acquisition Card
Connection to a UPS With a U-Talk Port
Illustration 3 g01996124
The default settings for the card are for this type of connection. Illustration 3 shows the corresponding positions of the jumpers and DIP switches. Before