BOLT 6C5304 - Caterpillar

Ensure that all safety information, warnings, and instructions are read and understood before any operation or any maintenance procedures are performed.The user is responsible for the performance of maintenance. Maintenance includes all adjustments, the use of proper lubricants, fluids, filters, and the replacement of components due to normal wear and aging. Failure to adhere to proper maintenance intervals and procedures may result in diminished performance of the product and/or accelerated wear of components.Use mileage, fuel consumption, service hours, or calendar time, WHICH EVER OCCURS FIRST, in order to determine the maintenance intervals. Products that operate in severe operating conditions may require more frequent maintenance.Note: Before each consecutive interval is performed, all maintenance from the previous interval must be performed.When Required
Battery - Recycle
Battery - Replace
Battery or Battery Cable - Disconnect
Circuit Breakers - Reset
Engine - Clean
Fuel System - Prime
Generator - Dry
Generator Bearing - Replace
Generator Set - Test
Generator Set Alignment - Check
Generator Winding - Test
Varistor - Inspect
Daily
Control Panel - Inspect/Test
Coolant Level - Check
Engine Air Cleaner Service Indicator - Inspect
Engine Oil Level - Check
Fuel System Primary Filter/Water Separator - Drain
Fuel Tank Water and Sediment - Drain
Generator Bearing Temperature - Test/Record
Generator Load - Check
Power Factor - Check
Walk-Around Inspection
Every Week
Air Inlet Filter - Inspect/Clean/Test
Automatic Start/Stop - Inspect
Battery Charger - Check
Electrical Connections - Check
Fuel System Primary Filter/Water Separator - Drain
Generator - Inspect
Generator Lead - Check
Space Heater - Test
Standby Generator Set Maintenance Recommendations
Stator Winding Temperature - Test
Voltage and Frequency - Check
Initial 250 Service Hours
Engine Valve Lash - Check
Fuel Injector - Inspect/Adjust
Every 250 Service Hours
Battery Electrolyte Level - Check
Belts - Inspect/Adjust/Replace
Coolant Sample (Level 1) - Obtain
Cooling System Supplemental Coolant Additive (SCA) - Test/Add
Fan Drive Bearing - Lubricate
Initial 500 Hours (for New Systems, Refilled Systems, and Converted Systems)
Coolant Sample (Level 2) - Obtain
Every 1000 Service Hours
Engine Protective Devices - Check
Every 1500 Service Hours
Engine Crankcase Breather - Clean
Fumes Disposal Filter Element - Replace
Every 2000 Service Hours
Engine Mounts - Inspect
Fuel Injector - Inspect/Adjust
Generator Set Vibration - Inspect
Generator Winding Insulation - Test
Stator Lead - Check
Every 2000 Service Hours or 6 Months
Generator Set Vibration - Test/Record
Every 2000 Service Hours or 1 Year
Radiator - Clean
Every Year
Coolant Sample (Level 2) - Obtain
Engine Air Cleaner Element (Dual Element) - Inspect/Clean/Replace
Generator Bearing - Lubricate
Water Pump - Inspect
Every 3 Years
Coolant Temperature Regulator - Replace