BOLT 6J4302 - Caterpillar

Remove Camshaft Bearings
Start By:a. remove cylinder head *b. remove camshaft*The cylinder head must be off the engine to allow the cam bearing removal and installation tooling to be installed. 1. Remove the bolts and rear cover (1) from the cylinder head. Check the condition of O-ring seal (2). If O-ring seal (2) appears worn or damaged, use a new part for replacement. The procedure to remove the cam bearings is the same for each of the seven bearings. However, each bearing requires a different combination of tooling. 2. Remove cam bearing No. 7 (the rear cam bearing) as follows:a. Screw the 8M-8778 Stud into the 9U-7222 Cam Bearing Pilot. b. Insert the small diameter of Cam Bearing Pilot Tool (B) into the cam bearing as shown.c. Position Tooling (A) on the back of the cylinder head as shown. Note that the cylinder is rod retracted, and positioned against the cylinder head.d. Screw the 6V-4013 Threaded Rod into Tool (B). Install the 5P-8248 Washer and 2J-3506 Nut. Screw the 2J-3506 Nut on the 6V-4013 Threaded Rod until it contacts the cylinder. e. Actuate the hydraulic cylinder to remove the cam bearing from the cylinder head.f. Separate Tooling (B) from the 6V-4013 Threaded Rod. Remove the old cam bearing from Tooling (B).
Use the 9U-7223 Alignment Bushing when the 8S-8292 or 8S-8293 Extensions are attached to Tooling (B). The 9U-7223 Alignment Bushing will guide the extensions and help support weight of the tooling. Install 9U-7223 Alignment Bushing in the inside diameter of any cam bearing between the hydraulic cylinder and Tooling (B).
Example: Tooling (H) used to remove No. 1 camshaft bearing.3. Repeat Step 2 using Tooling (B) and:a. Tooling (C) to remove camshaft bearing No.6.b. Tooling (D) to remove camshaft bearing No.5.c. Tooling (E) to remove camshaft bearing No.4.d. Tooling (F) to remove camshaft bearing No.3.e. Tooling (G) to remove camshaft bearing No.2.f. Tooling (H) to remove camshaft bearing No.1 (front camshaft bearing).Install Camshaft Bearings
Make sure inside of the cylinder head is clean. Check the cam bores to make sure there are no burrs. Put a thin film of clean engine oil inside of the cam bearing bore and on each new camshaft bearing prior to installing.
The procedure to install the cam bearings is the same for each of the bearings. However, each bearing requires a different combination of tooling. The depth that