BOLT-12 POINT HEAD 6V5605 - Caterpillar

Personal injury can result from hot coolant, steam and alkali.At operating temperature, engine coolant is hot and under pressure. The radiator and all lines to heaters or the engine contain hot coolant or steam. Any contact can cause severe burns.Remove cooling system pressure cap slowly to relieve pressure only when engine is stopped and cooling system pressure cap is cool enough to touch with your bare hand.Do not attempt to tighten hose connections when the coolant is hot, the hose can come off causing burns.Cooling System Coolant Additive contains alkali. Avoid contact with skin and eyes.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide", for tools and supplies suitable to collect and contain fluids in Caterpillar machines.Dispose of all fluids according to local regulations and mandates.
See the appropriate topics in your machine's Operation and Maintenance Manual for all cooling system requirements.Change the engine coolant more frequently if you find any of the following conditions:
The cooling system is heavily contaminated.
The engine overheats.
You observe foaming in the radiator.
The oil cooler has failed and oil is in the coolant.
Fuel has contaminated the cooling system.
The cooling system contains non-Caterpillar products.It is important to replace the thermostat in order to avoid any unexpected failure of the thermostat. This is a good preventive maintenance practice that reduces the chances of unscheduled downtime. Failure to replace the thermostat on a regularly scheduled basis could cause severe engine damage.Note: If you are only replacing the thermostat, drain the coolant from the cooling system so that the level of the coolant is below the thermostat housing.Always operate Caterpillar engines with a thermostat because these engines have a shunt design cooling system.Note: Thermostats can be reused if the thermostats meet certain test specifications. The tested thermostats must not be damaged and the tested thermostats must not have an excessive buildup of deposits.
Never add coolant to an overheated engine. Engine damage could result. Allow the engine to cool first.
Park the machine on a hard, level surface. Allow the engine to cool and allow the radiator to cool.
Raise the hood in order to access the radiator.Note: See Operation and Maintenance Manual, "Engine Compartment Hood - Raise/Lower".
Illustration 1 g00491305
Slowly loosen the filler cap in order to relieve the pressure. Remove the filler cap.
Inspect the filler cap gasket. Replace the filler cap if the gasket is damaged.
Illustration 2 g00491309
Attach a hose to the nipple on the drain valve. Open the drain valve that is under the radiator. Allow the coolant to drain into a suitable container.Note: Always discard drained fluids according to local regulations.
Close the drain valve. Fill the cooling system with clean water and with a 6 to 10% concentration of cooling system cleaner. Install the filler cap.
Start the engine. Run the engine for 90 minutes.
Stop the engine. Drain the cleaning