BOLT-ADJUSTABLE 7W4757 - Caterpillar

Procedure For Hourmeter Programming
A new GSC+ with 0 hours is used as an example in the following procedure. The example sets the hours to a value of "1234". If the value of the hours is increased, this procedure is valid. Note: Service Mode cannot be entered when the engine control switch (ECS) is in the AUTO position.Note: Any active shutdown fault (FLASHING shutdown indicator) must be made inactive in order to access Service Mode. To temporarily change a shutdown fault from an active shutdown fault to an inactive shutdown fault, turn the ECS to the OFF/RESETposition. In order to permanently change a shutdown fault from an active shutdown fault to an inactive shutdown fault, the shutdown fault must not be present and the ECS must be turned to the OFF/RESET position. The GSC+ will not power up in the OFF/RESET position if the jumper from terminal 6 to terminal 9 is not installed on the ECS, and any active shutdown fault must be corrected before entering service mode.
Turn the ECS to the STOP position in order to shut down the engine. Enter service mode and enter the password. "OP 4" is showing on the lower display. See System Operations, "Password Entry OP3".
Press the "SCROLL UP" key four times. "OP 7" is showing on the lower display.
Press the "SELECT" key. The present hourmeter value is showing. 0 is the hourmeter value in this example.
Press the "SELECT" key. "000000" is showing. The first digit is flashing.
Press the "SCROLL RIGHT" key two times. "000000" is showing. The third digit is flashing.
Press the "SCROLL UP" key. "001000" is showing. The third digit is flashing.
Press the "SCROLL RIGHT" key. "001000" is showing. The fourth digit is flashing.
Press the "SCROLL UP" key two times. "001200" is showing. The fourth digit is flashing.
Press the "SCROLL RIGHT" key. "001200" is showing. The fifth digit is flashing.
Press the "SCROLL UP" key three times. "001230" is showing. The fifth digit is flashing.
Press the "SCROLL RIGHT" key. "001230" is showing. The sixth digit is flashing.
Press the "SCROLL UP" key four times. "001234" is showing. The sixth digit is flashing.
Press the "ENTER" key. "001234" flashes on the lower display and "ArE YOU SUrE" is showing on the upper display.
For yes, press "ENTER" key. "001234" stops flashing.
For no, press "SELECT" key. "000000" is showing. The first digit is flashing. Repeat this procedure to program the hourmeter again.Note: The original hourmeter value can be stored in the GSC+ memory. When the display shows "ArE YOU SUrE", press the "EXIT" key twice for a normal display. The original hourmeter display remains in the GSC+.Note: Entering less hours into the GSC+ memory is not allowed. The display will briefly show "ErrOr". The display then shows the original hours that are stored in the GSC+. The first digit will be flashing.
Press "EXIT" key. "OP 1" is showing on the lower display.
Press "EXIT" key. The display returns to normal mode. As the engine data scrolls, the programmed value should show on the lower display.