BOLT 7X0440 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 138-7573 Link Bracket 3
B 1U-9200 Lever Puller Hoist 1
C 4C-5593 Anti-Seize Compound -
D 4C-9505 Gasket Sealant -
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Install the gaskets, O-ring seals, and the spacer plate on the engine. Install the spacer plate gasket with the following procedure.Note: Thoroughly clean the spacer plate, the bottom surface of the cylinder head, and the top surface of the cylinder block. A new spacer plate gasket and a cylinder head gasket must be installed when the cylinder head is removed.Note: Apply a thin film of clean engine oil on the O-ring seals prior to installation.
For best results, clean all surfaces and dry all surfaces with a solvent that is free of residue.
Apply Tooling (D) as a uniform film to the bottom side of the spacer plate gasket. Position the spacer plate gasket.
Apply Tooling (D) as a uniform film to the top side of the spacer plate gasket. Formulas that dry more slowly increase the time for the procedure.
Once the repairs are completed and the sealant has had adequate time to cure, the engine can be run.
If necessary, Tooling (D) can be removed from metal surfaces with isopropyl alcohol.
Illustration 1 g01194872
Illustration 2 g01148791
Attach Tooling (A) and a suitable lifting device to cylinder head (22). Attach Tooling (B) to the side of cylinder head (22) that is near the turbocharger. The weight of cylinder head (22) is approximately 330 kg (726 lb).
Position cylinder head (22) on the dowel pins in the cylinder block.Note: Apply Tooling (C) to the bolt threads and both sides of the washers.