BOLT 7X2592 - Caterpillar

Table 1
Required Tools
Tool Part No Description Qty
A(1) 198-4234 Digital Indicator 1
B(1) 198-4236 Adapter Cable As 1
C(1) 198-4237 Pressure Sensor Gp (0-3450 kPa) (0-500 psi) 1
D 4C-6500 Digital Thermometer 1
(1) Tool (A), Tool (B), and Tool (C) are part of the 198-4240 Digital Pressure Indicator Gp.
Drive the machine to a smooth, horizontal surface on loose, uncompacted soil. Note: If loose, uncompacted soil is not available, isolate the drum from the ground during this test.
Illustration 1 g02962397
Move propel lever (1) to the NEUTRAL position.
Move parking brake switch (2) to the ON position.
Illustration 2 g02962456
Use throttle control switch (3) in order to operate the engine in ECO mode or in low idle. Note: Two things indicate when the engine is in ECO mode. First, "ECO" will appear on the display. Second, the second LED next to throttle control switch (3) will be illuminated. Two things indicate when the engine is at low idle. First, "Low Idle" will appear on the display. Second, the first LED next to the throttle control switch will be illuminated.
Illustration 3 g02962460
Move engine start switch (4) to the OFF position.
Assemble the tooling. Connect Tool (C) to Tool (B). Connect Tool (B) to Tool (A).
Illustration 4 g02962465
Connect Tool (C) to charge pressure tap (5).
Move engine start switch (4) to the START position. Release the switch when the engine starts.
Operate the engine at low idle for a few minutes. Use throttle control switch (3) in order to operate the engine in high idle. Note: Two things indicate when the engine is at high idle. First, "High Idle" will appear on the display. Second, the third LED next to throttle control switch (3) will be illuminated.
Monitor the hydraulic oil temperature with Tool (D). Operate the machine until the oil temperature reaches 38 °C (100 °F).
Record pressure on Tool (A).
Illustration 5 g02962477
Use amplitude select switch (6) in order to set the vibratory system in the low amplitude mode. Note: Two things indicate when the vibratory system is in the low amplitude mode. First, "Vibe Amplitude Mode Low" will appear on the display. Second, one of LEDs next to amplitude select switch (6) will be illuminated.
Use vibratory mode switch (7) in order to set the vibratory system in the manual mode. Note: Two things indicate when the vibratory system is in the manual mode. First, "Vibe Mode Manual" will appear on the display. Second, none of the LEDs next to amplitude select switch (6) will be illuminated.
Move parking brake switch (2) to the OFF position.
If the drum has not been rotated within the past 3 minutes, rotate the drum one full revolution. This step is required in order to lubricate the vibratory shaft bearings.
Illustration 6 g02962481
Depress vibratory switch (8) on top of propel