BOLT 8F3152 - Caterpillar

The EMCP 4.2 has an internal real-time clock that is used for time-stamping events and programmable cycle timer. After the internal battery fails, the real-time clock will continue to keep time only when the control battery power is connected. If the control battery power is disconnected, then the real-time clock must be reprogrammed when the EMCP 4 is powered up again.Changing the Time/Date
The EMCP 4.2 clocks allow the time/date to be modified. Changing the time/date will change the timestamp on all future events, but not for existing events. (For example, an event that has occurred previously will still show the same first time/date, but if it occurs again after the time/date has been adjusted, the last time/date will reflect the change.)This procedure must be performed on the EMCP 4 display. This procedure cannot be done using the Cat ET. In order to update time/date, level 1 access is required.To change the time/date, follow the Steps below:
Illustration 1 g02277973
At the main menu, select "CONFIGURE". Press the "OK" key.Refer to Illustration 1.
Illustration 2 g02277974
Select "TIME/DATE". Press the "OK" key.Refer to Illustration 2.
Illustration 3 g02277975
To edit the time, press the "OK" key while the current time is selected.Refer to Illustration 3.
Illustration 4 g02277976
Press the "OK" key again to enter the editor.Refer to Illustration 4.
Press the left key or the right key to select a digit. Press the up key or the down key to change the selected digits. Press the "OK" key to accept the changes. Press the escape key to cancel the changes.Refer to Illustration 4.To change the Date from this Point
Illustration 5 g02277975
Press the escape key again to return to the "SET TIME/DATE" screen.Refer to Illustration 5.
Illustration 6 g02277978
Press the right key to place the box around the date.Refer to Illustration 6.
Illustration 7 g02277977
Press the "OK" key to enter the editor.Refer to Illustration 7.
Press the left key or the right key to select a digit. Press the up key or the down key to change the selected digits. Press the "OK" key to accept the changes. Press the escape key to cancel the changes.Changing the Date Format
The data format can be set to either display in the form Month/Day/Year or the form Day/Month/Year. This procedure must be performed on the EMCP 4.2 display. This procedure cannot be performed with Cat ET.Note: This preference does not affect operation of the EMCP 4 or the data as viewed in Cat ET. It only affects how the date is displayed on the EMCP 4 display and the format of the event time stamps.To change the date format, do the following:
Illustration 8 g02277973
At the main menu, select "CONFIGURE". Press the "OK" key.Refer to Illustration 8.
Illustration 9 g02277974
Select "TIME/DATE". Press the "OK" key.Refer to Illustration 9.
Illustration 10 g02278014
To edit the date, press the "OK" key while the current date is selected.Refer to Illustration 10.
Illustration 11 g02278015
Press the left key or the right key to select the format. Press the "OK" key to accept the changes. Press the escape key to cancel the changes.Refer to Illustration 11.