BOLT 8T4910 - Caterpillar

Removal Procedure
Start By:
If equipped with a radiator, remove the fan. Refer to Disassembly and Assembly, "Fan - Remove and Install" for the correct procedure.
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products.Dispose of all fluids according to local regulations and mandates.
Drain the coolant from the cooling system into a suitable container for storage or disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change" for the correct draining and filling procedures.
Illustration 1 g03654032
Loosen hose clamps (1). Disconnect hose assembly (3) from the water pump inlet.
Loosen hose clamps (4). Disconnect tube assembly (2) from the water pump inlet.
Illustration 2 g03654028
Remove bolts (5) and bolts (8).
Remove water pump (6) from front cover (9). Note: If necessary, tap the water pump with a soft faced hammer in order to loosen the water pump.
Remove gasket (7).
Illustration 3 g03654042
If necessary, follow Step 7.a through Step 7.c in order to remove adapter elbow (11).
Mark temporary mark on adapter elbow (11) for installation purposes.
Loosen locking nut (10) and remove adapter elbow (11) from water pump (6).
Remove O-ring seal (12) from adapter elbow (11). Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A - Guide Studs
M8 by 90 mm 2
Ensure that the water pump is clean and free from wear and damage. If necessary, replace the water pump.
Illustration 4 g03654042
If necessary, follow Step 2.a through Step 2.c in order to install adapter elbow (11).
Install a new O-ring seal (12) to adapter elbow (11).
Install adapter elbow (11) from water pump (6) ensure that the adapter elbow is aligned to the original position.
Tighten locking nut (10) hand tight.
Illustration 5 g03654029
Illustration 6 g03654028
Clean the gasket surface of housing (9).
Install Tooling (A) in Position (X).
Use Tooling (A) in order to align new gasket (7) to housing (9). Install the gasket onto the housing.
Align water pump (6) to Tooling (A). Install the water pump to housing (9). Note: Ensure that the gear of the water pump and the gear of the fuel injection pump are in alignment.
Install bolts (5) and bolts (8). Tighten the bolts finger tight.
Remove Tooling (A) and install remaining bolts (8).
Illustration 7 g03654031
Typical example
Illustration 8 g03654121
Tighten bolts (5) and bolts (8) to a torque of 22 N m (195 lb in) in the sequence that is shown in Illustration 7 .
Connect tube assembly (2) to the water pump inlet. Tighten the tube nut for the tube assembly hand tight.
Tighten hose clamps (4) to a torque of 7 N m (62 lb in).
Tighten locking nut (10) to a torque of 90 N m (66 lb ft).
Tighten the tube nut for tube assembly (2) to a torque of 90 N m (66 lb ft).
Connect hose assembly (3) to the