BOLT 9M7444 - Caterpillar

Assembly Procedure
Table 1
Required Tooling
Tool Part Number Part Description Qty
A 207-1601 Rubber Lubricant 1
Illustration 1 g06145776
Install plug (14) and seal (11).Note: Apply a light coat of Tooling (A) to the shaft chamfer and the seal running surface. Avoid ceramic sealing surfaces.
Install shaft (12), thrust washers (8), and bolts (7).Note: While installing shaft (12), slowly turn shaft (12) until thrust washers (8) bottoms with the housing.
Illustration 2 g06145790
Lightly coat shaft (12) with clean engine oil prior to installation of impeller (9).
Install seal (10) on to shaft (12) to a working height of 11.303 0.127 cm (4.45 0.05000 inch).
Install impeller (9) to a depth of 0.00 0.15 mm (0.00000 0.00591 inch) with the end of the shaft (12).
Illustration 3 g06145805
Lower temperature of bearing (13). Install bearing (13) in the housing assembly. Make sure that the oil hole in bearing (13) is aligned with the oil passage in housing assembly (X). Bearing (11) must be installed to a depth of 1.5 0.5 mm (0.02 0.02 inch). After assembly, the inner diameter of bearing (13) must be 75.000 0.055 mm (2.9527 0.0022 inch)
Illustration 4 g06145816
Install plug (6), plug (5), plugs (4), and plug (3).
Illustration 5 g06145819
Lightly lubricate the seal groove in adapter (2) with clean engine oil. Install the O-ring seal, adapter (2), and bolts (1).End By:
Install auxiliary water pump.