BOLT 9W9265 - Caterpillar

Refer to the Owners Manual of the OEM for your type of controls. Use the following procedure in order to start the engine.Note: Do not use ether or other starting aids to start the engine.
Explosion Hazard! Spraying uncontrolled ether into the air inlet system can cause explosions or fire that may result in personal injury or death. Read and follow the starting procedures in the Operation and Maintenance Manual.
Startability will be improved at temperatures below 10°C (50°F) from the use of a cylinder block coolant heater or from other means that are used to heat the crankcase oil. Some engine applications use a jacket water heater to improve startability. The jacket water heater will help reduce white smoke and misfire during start-up in cold weather.Note: If the engine has not been run for several weeks, fuel may have drained. Air may have moved into the filter housing. Also, when fuel filters have been changed, some air will be left in the filter housing. Refer to the Operation and Maintenance Manual, "Fuel System - Prime" (Maintenance Section) for more information on priming the fuel system.
Do not engage the starting motor when flywheel is turning. Do not start the engine under load.If the engine fails to start within 30 seconds, release the starter switch or button and wait two minutes to allow the starting motor to cool before attempting to start the engine again.
Place the transmission in NEUTRAL. Disengage the flywheel clutch in order to allow the engine to start faster and reduce the drain on the battery.
Turn the ignition switch to the ON position. The "CHECK ENGINE/DIAGNOSTIC" lamp will flash while the engine is cranking. The lamp should turn off after proper engine oil pressure is achieved. If the lamp fails to flash, notify your authorized Caterpillar dealer. If the lamp continues to flash, the Electronic Control Module (ECM) has detected a problem in the system. Refer to the Operation and Maintenance Manual, "Diagnostic