BONNET-OIL COOLER 7N7643 - Caterpillar

UPSView Commands And Hotkeys
Table 1
UPS Command Table    
Name    Hotkey    Password Level    
Enable Printing of Startup Errors     \     None    
Silence Display Buzzer     B     None    
Change Display Owner to MMU 1     Alt-1     None    
Change Display Owner to MMU 2     Alt-2     None    
Change Redundant MMU     Alt-B     Service    
Send Sys Cal Factors     Alt-C     Service    
Change Display Owner to this MMU     Alt-D     None    
Ethernet Loopback Test     Alt-E     None    
Force Op Params     Alt-F     Service    
Report AVR Demand FPGA Reading     Alt-G     None    
EPO Switch Status     Alt-I     None    
Show Ethernet Statistics     Alt-J     None    
Synchronize Event Logs     Alt-L     None    
Dump MMU Status Registers     Alt-M     None    
Toggle Debug Messages     Alt-N     Service    
Toggle Op Params Sent Over Can     Alt-O     Service    
Cancel Paging     Alt-P     Service    
Enter Regulation Only Mode     Alt-R     Service    
Enter AVR Spin Down Mode     Alt-S     Service    
Show Telemetry and Status Registers     Alt-T     None    
Show B-N (or Ground) Voltage     Alt-U     None    
Verify PCC Configuration     Alt-V     Service    
Toggle Discharge Walk in to Input VAC     Alt-W     Service    
Report Op Params that are not defaults     Alt-Z     None    
Start Genset     Control-[     Service    
Show Bypass Status     Control-\     None    
Stop Genset     Control-]     Service    
Send Op Params     Control-_     None    
Send Tile Definitions     Control-A     None    
Enter Bypass Mode     Control-B     Service    
Resend Cal Prompt     Control-C     Service    
Download Event Log     Control-D     None    
Get Password Seed and Serial Number     Control-F     None    
Dump IGBT Currents     Control-G     None    
Show Hotkeys     Control-H     None    
Load default 60 Hz Op Params to Flash     Control-I     Service    
Show Diagnostic data     Control-J     Service    
Toggle Discharge Disable     Control-L     Service    
Show Revision Information     Control-N     None    
Enter Online Mode     Control-O     Service    
Clear View Password     Control-P     Service    
Reset Modem NVRAM to Default     Control-Q     Service    
Reset the Processor     Control-R     Service    
Enter Bypass Spin Down Mode     Control-S     Service    
Toggle Vacuum Level Checking     Control-V     Service    
Toggle Modem On/Off Hook     Control-W     None    
Brake the Rotor     Control-X     Service    
Report Modem Configuration     Control-Y     None    
Dump Setpoints     Control-Z     Service    
Download Binary Event Log     Menu Only     None    
Generate Test Alarm     Menu