BONNET 7W3382 - Caterpillar

PARTS NEEDED
Qty
Part Number Description
1 3307292 GASKET (As Required)
In order to allow equitable parts availability to all participating dealers, please limit your initial parts order to not exceed 40% of dealership population. This is an initial order recommendation only, and the ultimate responsibility for ordering the total number of parts needed to satisfy the program lies with the dealer.
ACTION REQUIRED
Use the following steps to disassemble the harness, inspect for the gasket, and install the gasket if not already in place.
1. Remove the ECM connector cover by removing the four attaching screws.(Image 1 and 2)
2. Remove the connector from the ECM. (Image 3)
3. Remove the lower cover from the connector. (Image 4)
4. Remove clips and pull the conduit from the adapter. (Image 5)
5. Inspect the end of the conduit that engages the adapter for the gasket.
6. If a gasket is in place around the conduit, proceed to Step 10 and reassemble the conduit and connector.
7. If a gasket is not in place, cut across the 3307292/">330-7292 gasket as shown in Image 6.
8. Place a small bead of non-corrosive RTV silicone (8T-0065) on the gasket as shown in Image 7.
9. Assemble the gasket on the conduit.
10. Install the conduit into the adapter with the joint located towards the engine.
11. Install the lower ECM connector cover and install the connector onto the ECM.
12. Install the ECM connector top cover.
Image1
Image2
Image3
Image4
Image5
Image6
Image7
OWNER NOTIFICATION
U.S. and Canadian owners will receive the attached Owner Notification.
SERVICE CLAIM ALLOWANCES
Caterpillar Dealer Suggested Customer Suggested
Parts % Labor Hrs% Parts % Labor Hrs% Parts % Labor Hrs%
100% 100% 0% 0% 0% 0%
This is a 1.0-hour job
PARTS DISPOSITION
Handle the parts in accordance with your Warranty Bulletin on warranty parts handling.
MAKE EVERY EFFORT TO COMPLETE THIS PROGRAM AS SOON AS POSSIBLE.
COPY OF OWNER NOTIFICATION FOR U.S. AND CANADIAN OWNERS
XYZ Corporation
3240 Arrow Drive
Anywhere, YZ 99999
PRIORITY - PRODUCT IMPROVEMENT PROGRAM FOR INSPECTING AND POSSIBLY INSTALLING THE 3307292/">330-7292 GASKET IN THE ENGINE HARNESS ON CERTAIN G3508, G3512, AND G3516 ENGINES
MODELS INVOLVED - G3516, G3512, and G3508 Engines
Dear Caterpillar Product Owner:
The engine harness needs to be inspected and a gasket may need to be installed on the products listed below. The engine harness may not have a gasket installed and can allow the flexible ignition harness to fill with rain water. You will not be charged for the service performed.
Contact your local Caterpillar dealer immediately to schedule this service. The dealer will advise you of the time required to complete this service.
Please refer the dealer to their Service Letter dated 14Aug2008 when scheduling this service.
We regret the inconvenience this may cause you, but urge you to have this service performed as soon as possible to prevent unscheduled downtime.
Caterpillar Inc.
Identification #(s)
Attached to 14Aug2008 Service Letter