BOOM AR- 3157246 - Caterpillar

Illustration 27 g02568302
Press down key (12) until "Service" is highlighted on the display screen.
Press OK key (13) .
Illustration 28 g02568305
Press down key (12) until "Calibrations" is highlighted on the display screen.
Press OK key (13) .
Illustration 29 g02571225
Press down key (12) until "Right Auger" is highlighted on the display screen.
Press OK key (13) .
Illustration 30 g02571226
Press OK key (13) to begin the calibration.
Illustration 31 g02571228
Illustration 32 g02571230
Move right auger switch (14) to the AUTO position.
Illustration 33 g02568459
Squeeze trigger (15), and move propel lever (1) to the FORWARD position.
Press OK key (13) .
Illustration 34 g02571241
Illustration 35 g02571243
Right Screed Operator Station on AS2302C Screed
Illustration 36 g02571257
Right Screed Operator Station on AS3301C Screed
Illustration 37 g02571258
Right Screed Operator Station on AS4252C Screed
Rotate right material height dial (16), on the screed, to the MINIMUM position.
Press OK key (13) .
Illustration 38 g02571260
Rotate right material height dial (16) clockwise until the right auger just begins to operate.
Press OK key (13) .
Illustration 39 g02571261
Rotate right material height dial (16) clockwise until the speed of the right auger shaft reaches 150 10 rpm. Use Tool (A) to measure the speed.
Press OK key (13) .
Illustration 40 g02571263
The display should now read "CALIBRATION COMPLETE". Push back key (17) to return to calibration screen.
Push home key (11) to exit the calibration screen.
Move propel lever (1) to the NEUTRAL position.
Move right auger switch (14) to the OFF position.
Move throttle control switch (8) to the LOW IDLE position. Hold the switch in this position for less than 1 second.
After the engine reaches low idle, move engine start switch (9) to the OFF position.