BOOSTER AS 0917402 - Caterpillar

Press the up key or the down key to set the brightness of the image that is shown by the rear view camera between "0" and "22".
Press the OK key."Brightness (Night)"
The "BRIGHTNESS (NIGHT)" menu allows the operator to adjust the brightness of the image that is shown by the rear view camera for viewing at night.
Table 68
"VIDEO MODE SETTING"
"BRIGHTNESS"
"22"
"BRIGHTNESS (NIGHT)"
"22"
"CONTRAST"
"7"
Press the up key or the down key to highlight the "BRIGHTNESS (NIGHT)" menu. Press the OK key.
Table 69
"VIDEO MODE SETTING"
"BRIGHTNESS"
"22"
"BRIGHTNESS (NIGHT)"
"22"
"CONTRAST"
"7"
Press the up key or the down key to set the brightness of the image that is shown by the rear view camera for viewing at night between "0" and "22".
Press the OK key.Contrast
The "CONTRAST" menu allows the operator to adjust the contrast of the image that is shown by the rear view camera.
Table 70
"VIDEO MODE SETTING"
"BRIGHTNESS"
"22"
"BRIGHTNESS (NIGHT)"
"22"
"CONTRAST"
"7"
Press the up key or the down key to highlight the "CONTRAST" menu. Press the OK key.
Table 71
"VIDEO MODE SETTING"
"BRIGHTNESS"
"22"
"BRIGHTNESS (NIGHT)"
"22"
"CONTRAST"
"7"
Press the up key or the down key to set the contrast of the image that is shown by the rear view camera between "0" and "15".
Press the OK key.Monitor Starting, Switching, and Termination
Monitor Starting
If "VIDEO MODE" is set to "ON" the image that is shown by the rear view camera is displayed when the engine starts.Note: If a warning is detected, the image that is shown by the rear view camera will not be displayed when the engine starts.Monitor Switching From the Rear View Camera Image to the Default Screen
Press any key to return to the default display from the image that is shown by the rear view camera.If any of the following conditions are found, the monitor will return to the default display automatically:
New warning is found.
The engine coolant temperature gauge reaches level 10.
The hydraulic oil temperature gauge reaches level 10.
The fuel level gauge reaches level 10.Note: When the crane system is active the image that is shown by the rear view camera cannot be displayed continuously. Press the OK key to display the image from the rear view camera.Monitor Switching From the Default Screen to the Rear View Camera Image
To display the image from the rear view camera from the default display, press the OK key.Note: This operation is only valid when the default screen is displayed.Monitor Termination
If the rear view camera is displayed and the engine start switch is turned to the "OFF" position, the monitor will terminate after the default display is shown for 3 seconds.If the default display is shown and the engine start switch is turned to the "OFF" position, the monitor will terminate immediately.