BOOSTER AR. 2D2002 - Caterpillar

Table 1
Parts List    
Description     Former Part Number of Keypad     New Part Number of Keypad     Former Part Number of Decal     New Part Number of Decal    
15 Key Pad (Left Side)     161-5222     194-1468     161-4932     188-7243    
15 Key Pad (Right Side)     161-5223     194-1467     161-4933     188-7242    
10 Key Pad (Left Side)     161-5213     191-3056     173-0108     188-7245    
10 Key Pad (Right Side)     161-5213     191-3056     173-0108     188-7244    
Table 2
Parts List    
Quantity     Part Number     Description    
2     195-1337     Rod    Removal Procedure
Refer to Service Manual module, RENR3016, "Disassembly and Assembly, 550 Wheel Harvester, 570 Wheel Harvester, and 580 Wheel Harvester Machine Systems", "Preparation for Disassembly" for instruction on preparing the wheel harvester for disassembly.
Turn the two battery disconnect switches to the OFF position. The two battery disconnect switches are located on the left side of the engine compartment.
Illustration 1 g00707457
(1) Former keypad. (2) Keypad film.
Illustration 2 g00740009
(3) Former Rod.
Remove former keypad (1), film (2), and rod (3).
For machines with a keypad that has 10 buttons, remove the wires from the 16 pin connectors. Mark the locations of the wires so the wires can be installed into the connectors of the new keypads.
Illustration 3 g00707455
New keypad with 15 keys
Install the new keypad and rod.
Install the new decals.
Illustration 4 g00740024
Underside of the armrest
Route the wiring harness from the keypad through the clips which are located under the armrest. The routing is shown in illustration 4.Replacement of the Keypad with 15 Buttons
Illustration 5 g00740044
Interface box on back of seat
Unplug two 10-pin connectors (4) from the former keypad. Plug the 10-pin connectors from the new keypads into the interface box. Plug the 10-pin connector with seven wires in the connector port that is closest to the side of the box.
Illustration 6 g00740114
Wire routing.
Route the wire on the back of the seat. The routing is shown in the above illustration. Replacement of the Keypad with 10 ButtonsNote: The replacement keypad for the former keypad with 10 buttons has 15 buttons.
Insert the wires that were removed in Step 4 into the new connector at the locations that were marked.
Illustration 7 g00741659
Connect the connector for left keypad (6). Connect the connector for right keypad (5) .