BOOT 0918402 - Caterpillar

Front of the Machine
Illustration 1 g01778093In order to lift the front of each side of the machine, use suitable tooling that can be secured in the raised position (55 ton minimum capacity). Place this tooling under the flat surface on the bottom on casting (1) which is used to mount the front suspension cylinder. In order to secure the front suspension cylinder on each side of the machine, use suitable tooling that can be mechanically secured in the raised position (20 ton minimum capacity). Place this tooling under front suspension cylinder (2) in order to prevent the extension of the cylinder.Rear of the Machine
Illustration 2 g01778094In order to raise the rear of the machine, use suitable tooling that can be mechanically secured in the raised position (55 ton minimum capacity). Place this tooling under the flat surface on the bottom of rear end housing (3).Note: Do not attempt to raise the rear of the machine with the lift stands between the two rear suspension cylinders.Frame (Rear)
Illustration 3 g01947249
Typical example of the right side
In order to raise the rear of the frame, use suitable tooling that can be mechanically secured in the raised position (20 ton minimum capacity). Place this tooling under the flat surface on the bottom of frame support (4) for the hoist.The flat surface on the bottom of the frame support for the hoist is not intended to raise any portion of the machine off the ground.