BOOT 2356353 - Caterpillar

1. Remove nuts (1), and move clip (2) and the hose away from cover (3).2. Remove cover (3) and the gasket. 3. Remove the bolts that hold cover (4) to the ring, and remove the cover. 4. Remove the four bolts and ring (5). 5. Remove gear (7) from the front of the fuel injection pump camshaft (6).Install Fuel Injection Pump & Governor Drive
1. Remove the plug from the timing pin hole, and put Tool (A) in the timing pin hole.2. Install two 7/16"-20 NF x 4"long bolts in fuel injection pump camshaft (1). Slowly rotate the fuel injection pump camshaft until Tool (A) goes into the groove in the fuel injection pump camshaft. Remove the bolts. 3. Put No. 1 piston at the top center compression position (TC) with the following procedure.a. Remove the plug and cover from the left side of the flywheel housing, and install Tool (B) in the flywheel housing.b. Use Tool (B) to slowly rotate the engine in the direction of normal rotation (counterclockwise as seen from the flywheel end of the engine) until timing bolt (2) [the long bolt that holds the cover to the flywheel housing] can be installed in the flywheel housing and into the hole in the flywheel. c. Remove the valve cover from the valve cover base. Check to see if both rocker arms (3) for the No. 1 cylinder can be moved backward and forward. The No. 1 piston is at the top center compression stroke when