BOOT 6E4537 - Caterpillar

Introduction
The following procedure is used in order to adjust the timer cycle for the Autolube system.Required Tools
Illustration 1 g02112000
Table 1
Required Tools    
Tool     Description     Qty    
D     Caterpillar Electronic Technician (ET)     1    Machine Preparation
ReferenceBefore you perform this adjustment, refer to Testing and Adjusting, "Machine Preparation for Troubleshooting".
Stop the machine on a hard level surface. Move the transmission control lever to the NEUTRAL position. Shut off the engine. Place blocks in front of the wheels and place blocks behind the wheels.
Engage the parking brake.
Connect tooling (D) to the machine. In order to configure the settings for the lubrication, go to the transmission/chassis Electronic Control Module (transmission/chassis ECM) in Cat ET. Select "Lube Parameters" in order to configure the settings for the lubrication system.Adjustment Procedure
Illustration 2 g01400210
Typical ExampleThe interval between the lubrication cycles has a default setting of 120 minutes. The cycle time can be adjusted using Caterpillar Electronic Technician (ET).The default setting for the duration of the lubrication pump is 240 seconds. The default setting can be adjusted with Cat ET. The pressure setting for the lubrication pump to turn OFF can also be changed in Cat ET. The default pressure setting is 18616 kPa (2700 psi).