BOWL ASSEM. 8S6455 - Caterpillar

4N5294 (Left hand front - to the rear)
(1) Heat bearing before installation to a maximum temperature of ... 149°C (300°F) Do not allow the bearing to touch the bottom or sides of the heater.7N8987 or 1W8581 (Left hand front - to the front)
(1) Seal. Put a small amount of clean engine oil on the lip of the seal for assembly.(2) Bearing. Put clean engine oil on the bearing as lubricant for assembly.(3) Tighten bolts in drive gear to a torque of ... 30 3 N m (22 2 lb.ft.)(4) Put 5P3413 Pipe Sealant on the threads of the studs at assembly.(5) O-ring seal. Put a small amount of clean engine oil in the bore for the O-ring seal at assembly.
1W8581 SHOWN7N8877 (Right hand front)
(1) Install dowels to a dimension of ... 9.7 0.8 mm (.38 .03 in.)(2) Seal. Put a small amount of clean engine oil on the lip of the seal at assembly. Install the seal with the lip toward the bearing as shown.(3) O-ring seal. Put a small amount of clean engine oil in the bore for the O-ring seal at assembly.(3408)
7N8750 & 7N8881 Auxiliary Drive Groups
7N8750 SHOWN(1) Tighten nut to a torque of ... 290 10 N m (210 7 lb.ft.)(2) O-ring seal. Put a small amount of clean engine oil or glycerine in the bore for lubrication at assembly.(3) Tighten nut to a torque of ... 108 7 N m (80 5 lb.ft.) Tighten more if needed to make an alignment of the slots and bend tab of the lock on nut.(4) Tighten the studs to a torque of ... 30 5 N m (22 4 lb.ft.)(5) Distance bearing is from end of housing ... 6.6 0.5 mm (.26 .02 in.)(6) Seal. Install seal with the lip toward the bearing as shown. Put a small amount of clean engine oil on the lip of the seal as lubricant for assembly.