BRACE 8S4919 - Caterpillar

Allow the welded area to cool prior to attempting to install the new 206-4466 Support Bracket (23) .
Fit the new 206-4466 Support Bracket (23) into position.
Install bolts (22) into the correct position, and torque to 105 20 N m (75 15 lb ft).
Install four 8T-4910 Bolts (24), four 7X-0550 Hard Washers , and four 146-5067 Spacers into the four mounting holes. Torque bolts (24) to a torque of 100 20 N m (70 15 lb ft).
Illustration 24 g00985214
Right Side Radiator Mounting Bracket (Engine Side)Completed Installation is Shown.
The right side radiator mounting bracket ( 206-4464 Support ) is replaced in the exact same manner as the left side radiator mounting bracket. Repeat steps 1 through 12 for the replacement of the radiator mounting bracket that is located on the right side of the machine.Reassembly Of the Radiator Group
Reference: For more information on assembly of the radiator system, refer to Disassembly and Assembly Manual, SENR1318, "814F Wheel Tractor, 815F Soil Compactor and 816F Landfill Compactor Machine Systems", "Radiator and Hydraulic Oil Cooler".
Illustration 25 g00984777
Fasten a suitable lifting device to the right hand panel assembly (18). Install the right hand panel assembly. Install four bolts (17) (four on each panel) that hold the panel assembly in position. Install the left side panel assembly in the same manner. The weight of each panel assembly is 50 kg (110 lb).
Illustration 26 g00984776
Install four bolts (16) and the washers (two on each side of the radiator guard) that hold the right and left panel assemblies of the radiator guard to the fan shroud.
Install four bolts (not shown) that hold brackets (15) for the air conditioning condenser in place. Install brackets (15) for the air conditioning condenser onto the machine.
Illustration 27 g00984762
Install fan guards (13) onto the mounting studs. Install bolts (14) and the washers that hold the upper fan guards and the lower fan guards (13) in position.
Illustration 28 g00984719
Connect wires (11) and wiring harness (12) onto each tail light.
Illustration 29 g00984714
Install cover (10) onto each tail light (9) .
Illustration 30 g00984710
By using two people, install the cover assembly. Install eight bolts (7) and the washers that hold cover assembly (8) in position. The weight of cover assembly is approximately 23 kg (50 lb).Note: Two of the eight bolts (7) and washers are located on the back of the cover. Six of the bolts (7) are located on the top of cover (8) .
Illustration 31 g00984707
Install the frame. Install six bolts (5) and washers that hold frame (6) in position. The frame weighs approximately 23 kg (50 lb).
Illustration 32 g00984693
Fasten a strap and a suitable lifting device to grill (2), as shown.
Illustration 33 g00984680
Install grill (2) onto the machine. Engage rod assembly (4) through hole (3) that is located in the lower channel of the radiator guard. The weight of the grill is 34 kg (75 lb).
Install bolt (1) and the washer. Close grill (2). Remove the lifting equipment from grill (2) at this time.
Install the air conditioning condenser.Reference: For more information on installation of the