AVSPARE.COM
parts catalog

BRACKET A 0877074 - Caterpillar



0877074 BRACKET A Caterpillar parts BRACKET
Rating:
16
Alternative (cross code) number:
CA0877074
087-7074
0877074
Caterpillar 0877074 BRACKET A

Buy BRACKET A 0877074 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


At operating temperature, the engine coolant is hot and under pressure.Steam can cause personal injury.Check the coolant level only after the engine has been stopped and the fill cap is cool enough to touch with your bare hand.Remove the fill cap slowly to relieve pressure.Cooling system conditioner contains alkali. Avoid contact with the skin and eyes to prevent personal injury.
Replace the water temperature regulator on a regular basis in order to reduce the chance of unscheduled downtime and of problems with the cooling system.The water temperature regulator should be replaced after the cooling system has been cleaned. Replace the water temperature regulator while the cooling system is completely drained. Replace the water temperature regulator while the cooling system coolant is drained to a level below the water temperature regulator housing.
Failure to replace the engine's water temperature regulator on a regularly scheduled basis could cause severe engine damage.
Note: If you are only replacing the water temperature regulator, drain the cooling system coolant to a level that is below the water temperature regulator housing.
Remove the cooling system pressure cap in order to relieve the pressure in the cooling system.
Illustration 1 g03705382
The water temperature regulator is located on the inside of a housing that is on the right side of the engine.
Remove the water temperature regulator housing.
Remove the gasket and remove the water temperature regulator.
The water temperature regulators may be reused if the water temperature regulators are within test specifications, are not damaged, and do not have excessive buildup of deposits.
Since Caterpillar engines incorporate a shunt design cooling system, it is mandatory to always operate the engine with a water temperature regulator.Depending on load, failure to operate with a water temperature regulator could result in either an overheating or an overcooling condition.
If the water temperature regulator is installed incorrectly, it will cause the engine to overheat.
Install a new water temperature regulator.
Reinstall the housing.
Add the cooling system coolant. Maintain the level of the coolant to the proper line on the sight glass.
Inspect cooling system pressure cap and the gasket for damage. Replace the pressure cap if the pressure cap or the gasket are damaged.
Install the cooling system pressure cap.
Check for leaks.


Parts bracket Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.