BRACKET 1014657 - Caterpillar

Illustration 1 g01143988
Compartment behind the Front Access Door ( 365C) (1) Front Access Door (2) Fuse Panel (3) Connector for Cat ET (4) Main Disconnect Switch (5) Machine ECM
Illustration 2 g01143766
Compartment behind the Front Access Door ( 385C) (1) Front Access Door (2) Fuse Panel (3) Connector for Cat ET (4) Main Disconnect Switch (5) Machine ECM
Illustration 3 g01144151
Location of the Machine ECM (5) Machine ECM (6) J1 Connector (7) J2 ConnectorThe Machine ECM (5) is located in the compartment behind the cab (Front Access Door) (1) .The engine control and these electronic controls can communicate with each other through the Cat Data Link. Information from these electronic controls can be accessed through the Monitoring System or by using the Caterpillar Electronic Technician (Cat ET) on a laptop computer.Connect a laptop computer with the software for the Cat ET to the connector (3) for the Cat Data Link. The Cat ET is used to obtain diagnostic information. The Cat ET is also used to program numerous functions on all of the electronic controls.The following references should be used to locate the electrical components and connectors: the Electrical System Schematic, the Parts Manual and the Operation and Maintenance Manual.The following information is a guideline to reading: the charts for Harness Connectors, the charts for Component Locations, the area views and the machine profile. All of these components can be found on the back of the Electrical System Schematic.Component Location Chart - The component location chart uses white circles as location labels in the machine profile and area views. The letters in the column for the "machine location" indicate a general area of the machine. See the corresponding footnote at the end of the chart for a description of the location."Harness Connector Location Chart" - The chart uses white circles as location labels in the general views and area views.Connector Contact Numbers
Machine Control ECM
Illustration 4 g00554751
Electronic Control Module (ECM)
Illustration 5 g00556522
Machine Harness Connectors J1 and J2 that mate to the ECM.