BRACKET 1215747 - Caterpillar

Troubleshooting Poor Accuracy
Problem List
The finished grade has incorrect slope
The finished grade is level but offset from desired gradeProbable Causes
The finished grade has incorrect slope
Incorrect slope entered on display
Incorrect slope entered on laser transmitter
The laser transmitter needs to be calibrated
Inclinometer is out of calibration
Cylinder sensors are out of calibration
Swing sensor is out of calibration
The incorrect work tool is active
The incorrect coupler is active
Incorrect orientation of transmitter with respect to the machine or incorrect orientation of the machine with respect to the transmitter while digging
Incorrect orientation of transmitter with respect to the machine or incorrect orientation of the machine with respect to the transmitter when benchmark setThe finished grade is level but offset from desired grade
The laser transmitter needs to be calibrated
Inclinometer is out of calibration
Cylinder sensors are out of calibration
Swing sensor is out of calibration
The incorrect work tool is active
The incorrect coupler is active
The electric mast is out of calibration
The incorrect layer mode is active
Incorrect depth entered on display
Incorrect measurement units selected
The laser beam is unstable
The laser transmitter setup is not secure
The laser transmitter is not setup in a proper location
Multiple laser transmitters operating in the same area
The laser receiver is detecting reflections or stray light sourcesTroubleshooting Erratic Elevation
Problem List
The grade indicators are changing erratically.Probable Causes
The Grade Indicators are Changing Erratically or have Poor Accuracy
The laser beam is unstable
The laser receivers are detecting reflections or stray light sources
The laser transmitter setup is not secure
The laser transmitter is not setup in a proper location
The laser transmitter battery needs to be charged
The laser transmitter needs to be calibrated
Tolerance has been set to tigh
Cylinder sensor failure
Inclinometer
Excessive worktool (tooth) wear
Excessive pin wearTroubleshooting the Laser Receiver
Problem List
The laser receiver is not detectedProbable Causes
The Laser Receiver Is Not Detected
Wire harness damaged
Wire connectors not tight
CAN terminators not installed correctly
Laser Receiver not installed