BRACKET AS-ENGINE 1432848 - Caterpillar

Illustration 6 g02609380
Install boot (20). Install clamp (22). Install retainer (21). Install hose assemblies (19). Install fittings (18).
Illustration 7 g02609379
Install hose assemblies (17). Install bracket (16).
Illustration 8 g02609377
Illustration 9 g02551745
Attach a suitable lifting device to Tooling (E). The weight of Tooling (E) is approximately 332 kg (732 lb). Remove plate (10). Drive pin (13) toward the boom to remove Tooling (E). Remove pin (15). Remove Tooling (E).
Illustration 10 g02566684
Illustration 11 g02609038
Attach a suitable lifting device to boom cylinder (12). The weight of boom cylinder (12) is approximately 181 kg (400 lb). Lower boom cylinder (12) onto Tooling (D). Position boom cylinder (12). Install pin (15) and the correct spacers.
Illustration 12 g02564118
Install hose assemblies (14).
Illustration 13 g02566686
Illustration 14 g02566718
Position boom cylinder (12), as shown. Drive pin (13) into position. Install plate (10) and bolts (11). Connect grease hose assembly (9).
Illustration 15 g02610897
Illustration 16 g02610898
Drain the final drives into a suitable container. Remove two bolts (1) and install Tooling (A), as shown. Remove remaining bolts (1). Tighten forcing bolts (3) to remove the cover (2) from the final drive. Remove the cover (2) while holding the ring gear against the sprocket housing.
Illustration 17 g02611717
Illustration 18 g02610902
Place bolt (1) in the ring gear to hold in position, as shown. Install sun gear (4).
Illustration 19 g02610898
Illustration 20 g02610897
Apply Tooling (A) onto the cover (2). Install cover (2) and bolts (1). Apply Tooling (A) to screws (3). Install screws (3) flush with cover (2). Refill with oil.