BRACKET AS 1465230 - Caterpillar

Install balls (31).
Illustration 9 g00712126
Install spring seat (27).
Illustration 10 g00712122
Install outer spring (23) and inner spring (22).
Illustration 11 g00712119
Install packing (3) in plug (8).
Illustration 12 g00712118
Install cap (2) and new O-ring seal (11) on plug (8).
Illustration 13 g00712111
Install pushrod (16) in plug (8).
Install piston (18) on pushrod (16).
Illustration 14 g00712108
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Install plug (8) and the pushrod in the body assembly.
Repeat Steps 3 through 15 in order to install the other three spool assemblies.
Illustration 15 g01021623
Install cover (25) and bolts (26). Tighten bolts (26) to a torque of 29 3 N m (22 2 lb ft).
Illustration 16 g01021622
Install bushings (20) in covers (24).
Illustration 17 g01021621
Install covers (24) and bolts (4). Tighten bolts (4) to a torque of 79 10 N m (58 7 lb ft).
Illustration 18 g01021620
Install setscrews (5) and nuts (17).
Illustration 19 g00711976
Install pedal (12) on the pilot valve.
Illustration 20 g00711974
Install camshaft (19) in pedal (12). Center camshaft (19) in pedal (12).
Install setscrew (6) in pedal (12). Tighten setscrew (6) to a torque of 6.9 1.0 N m (61.07 8.85 lb in).
Illustration 21 g00712296
Illustration 22 g01021620
Adjust setscrew (5) in order to set Dimension (a) for pedal (12) at 12.4° 0.6°.
Tighten nuts (17) to a torque of 33 3 N m (25 3 lb ft).
Repeat Steps 20 through 23 in order to install the remaining pedal. End By:
Install the pilot valve. Refer to Disassembly and Assembly, "Pilot Valve (Travel) - Install".