BRACKET 1906263 - Caterpillar

Illustration 1 g01375179
Schematic of the Left Front Drive Motor solenoidThis diagnostic code is associated with the Left Front Drive Motor solenoid (all wheel drive). The FMI 06 means that the ECM has determined that the current of the solenoid is above normal. The possible causes of this diagnostic code are listed:
The energize circuit of the solenoid is shorted to ground.
The solenoid has failed.
The ECM has failed. This is unlikely. Before performing this procedure, inspect the harness connectors that are involved in the circuit. Poor connections can often be the cause of a problem in an electrical circuit. Verify that all of the connections in the circuit are clean and verify that all of the connections in the circuit are secure. All of the connections must be in good condition. If a problem with a connection is found, correct the problem and verify that this diagnostic code is active before performing this procedure. Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear these diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 2293 FMI 06 is active before performing this procedure.Note: The resistance of the solenoid coil should be 8.7 .4 ohms at 25 °C (77.0 °F).System Response:The diagnostic code of CID 2293 FMI 06 will be logged in the internal memory of the All Wheel Drive (AWD) ECM.The AWD feature will be disabled.Test Step 1. CHECK THE SOLENOID
Turn the disconnect switch and turn the key start switch to the ON position. Do not start the engine.
Observe the status of the diagnostic code.
Disconnect the solenoid with the active diagnostic code from the machine harness. Expected Result:The active CID 2293 FMI 06 diagnostic code changes to a CID 2293 FMI 05 diagnostic code when the solenoid is disconnected.Results:
YES - The active CID 2293 FMI 06 diagnostic code changes to a CID 2293 FMI 05 diagnostic code when the solenoid is disconnected. The circuit is correct.Repair: The solenoid has failed. Repeat this test "CHECK THE SOLENOID" in order to verify the solenoid failure. Replace the solenoid.STOP
NO - The CID 2293 FMI 06 remains active when the solenoid is disconnected. The solenoid is not causing the problem. Proceed to Test Step 2.Test Step 2. CHECK THE ENERGIZE CIRCUIT OF THE SOLENOID FOR A SHORT TO GROUND
Turn the key start switch and turn the disconnect switch to the OFF position.
The solenoid remains disconnected from the machine harness.
Disconnect the machine harness connectors J1 and J2 from the AWD ECM.
At the ECM connectorJ1-58 of the machine harness, measure the resistance from contact J1-58 (wire 845-OR) to all of the other J1 and J2 contacts that are used in the AWD ECM connectors.Expected Result:Each resistance measurement is greater than 5000 ohms.Results:
OK - Each resistance measurement is greater than 5000 ohms. The machine harness is correct. Proceed to Test Step 3.
NOT OK - One or more of the resistance measurements is less than 5000 ohms. There is a short in the