BRACKET AS 1U0300 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 9S-9082 Engine Turning Tool 1
B 1P-1861 Retaining Ring Pliers 1
C 6V-4020 Piston Ring Expander 1
D 1U-7616 Piston Ring Compressor 1
E 334-0519 Grease -
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g00764680
Use Tooling (C) to install piston rings (6) on piston (3).
The ends of the oil control piston ring should be 180 degrees away from the oil ring end gap. The white-colored section of the oil ring spring should also be visible at the oil ring end gap.
Install the intermediate ring with the side that is marked "UP" toward the top of the piston. Position the intermediate ring with the green strip on the right side of the end gap.
Install the top piston ring with the red strip on the right side of the end gap.
The piston ring end gaps must be approximately 120 degrees away from each other after installation.
Illustration 2 g00764676
Place clean engine oil on piston pin (5), the piston pin bearing, and the bore in piston pin (5).
Position connecting rod (4) in piston (3) and install piston pin (5).
Use Tooling (B) to install the snap rings that hold piston pin (5).
Check the clearance of the bearings. Refer to Disassembly and Assembly, "Bearing Clearance - Check" for the correct procedure.
Install the upper half of the connecting rod bearing in connecting rod (5). Ensure that the tab on the back of the bearing is in the bearing tab groove on connecting rod (5).
Illustration 3 g00582933
Typical example
Place clean engine oil on the piston rings and the cylinder liner bore. Use Tooling (D) to compress the piston rings.
Install the piston and connecting rod assembly in the engine.
Ensure that the piston and connecting rod assembly is installed in the engine with the chamfer of the connecting rod bore adjacent to the crank pin thrust surface. The opposite side should also thrust against the mating rod on the crank pin.
Illustration 4 g00582418
Typical example
Install the lower half of the connecting rod bearing in connecting rod cap (2). Ensure that the tab on the back of the bearing is in the bearing tab groove on connecting rod cap (2).
Place clean engine oil on the upper half and on the lower half of the connecting rod bearing.
Apply Tooling (E) to the threads of the bolts and the threads in connecting rod caps (2).
Position connecting rod cap (2) on the connecting rod and install bolts (1) in connecting rod cap (2).
Refer to Disassembly and Assembly, "Connecting Rod Bearings - Remove and Install" for the correct tightening procedure of the bolts in the connecting rod cap.
Check the side clearance that is between two of the connecting rods that are on the same journal. The clearance must be 0.850 0.232 mm (0.0335 0.0091 inch).End By:
Install the piston cooling jets. Refer to Disassembly and Assembly, "Piston Cooling Jets - Remove and Install".
Install the cylinder head. Refer to Disassembly and Assembly, "Cylinder Head - Install".