BRACKET AS-FAN 1W9305 - Caterpillar

Disassemble Flywheel Clutch (Direct Drive And Special Application)
start by:a) remove flywheel clutch1. Put the flywheel clutch on wood blocks as shown. Remove the wire from the flywheel housing and ring. 2. Remove cotter pin and pin (1). Remove cotter pin and washer, and remove flywheel clutch brake (2). 3. Remove shaft (3). 4. Install two 1/2"-13 NC forged eyebolts and nuts in cover. Fasten a hoist to the cover. Remove cover (5). The weight of the cover is 170 lb. (77 kg).5. Remove six bolts from cage (4). Use a soft hammer to remove cage from cover. 6. Remove seal (6) from cage. Remove seal (7) from cage. 7. Remove six bolts (8), locks and cover (9) from cage. 8. Remove ring (10) and bearing (11) from cage. 9. Loosen two bolts (12) in yoke. 10. Pull the yoke forward as shown. Remove lever (13) and key from shaft (14). 11. Push shaft (14) in as shown. Remove key (16).12. Install a 3/8"-16 NC bolt in shaft (15). Pull shaft (15) out and remove the key from the shaft. Remove the shaft and yoke (17). 13. Remove the four bolts and two locks from gear (18). Remove gear (18) and washer (19). 14. Remove retainers, locks and springs from four studs (20). 15. Install two 1/2"-13 NC forged eyebolts in bracket. Fasten a hoist to the bracket. Weight of the bracket is 65 lb. (29 kg). Remove bracket (21). 16. Remove plate assembly (22) and four studs (24) from plate.17. Remove two bearings (23) from plate assembly. 18. Remove four pins (26) from collar. Remove collar (25). 19. Remove four links (28) and eight pins (27) from ring. Remove pins (27) from links (28). 20. Remove pin (31). Remove two rollers (29) and link (30). Disassemble the other three links. 21. Remove nut from lock assembly (33). Remove lock assembly (33) and plate. Remove plate assembly and plate from the other side of the bracket. Remove ring (32) from bracket. 22. Remove four bolts (34) and locks from collar. Remove collar (35). 23. Remove washer (36) and collar (37). 24. Remove washer (39), springs (38), pins and washer (40) from washer.Assemble Flywheel Clutch (Direct Drive And Special Application)
1. Install four pins (2) and four springs (1) in washer. 2. Install washer (5), collar (4) and washer (3). 3. Put collar (6) in position on the four pins. Install the four bolts and locks that hold the collar (6) to washer (3). 4. Put ring (7) in bracket (8) as shown. 5. Install the two lock assemblies (9) and two plates (10) in the bracket. Install the nuts on the two lock assemblies. 6. Put the two rollers (13) and link (11) in position. Install the pin that holds the rollers and link in position. Install two pins (12) and (14). Assemble the other three links. 7. Put four links (15) in position in ring as shown. 8. Put the collar (16) in position in the ring. Install four