BRACKET-MOUNTING 2228652 - Caterpillar

Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact skin.
Do not under fill or overfill engine crankcase with oil. Either condition can cause engine damage.
Park the machine on a level surface and engage the parking brake. Stop the engine.Note: Drain the crankcase while the oil is warm. This allows waste particles that are suspended in the oil to drain. As the oil cools, the waste particles will settle to the bottom of the crankcase. The particles will not be removed by draining the oil and the particles will recirculate in the engine lubrication system with the new oil.
Open the engine compartment access door on the left side of the machine, if the machine is equipped with engine compartment access doors.
Illustration 1 g00268337
Open the crankcase drain valve. Allow the oil to drain into a suitable container. Note: Discard any drained fluids and discard any filter elements according to local regulations.
Close the crankcase drain valve.
Illustration 2 g00268338
Clean the area around the engine oil filter before removing the engine oil filter. Remove the engine oil filter with a strap type wrench. See Operation and Maintenance Manual, "Oil Filter - Inspect".
Clean the base of the engine oil filter housing. Make sure that all of the old filter gasket is removed.
Apply a light coat of engine oil to the gasket of the new engine oil filter.
Install the new engine oil filter by hand. Additionally tighten the engine oil filter by 3/4 of a turn, after the gasket contacts the filter base.
Illustration 3 g00130732
Clean the area around the dipstick before removing the dipstick. Clean the area around the oil filler cap before removing the oil filler cap. Remove the oil filler cap (2). Fill the crankcase with new oil. See Operation and Maintenance Manual, "Refill Capacities". Clean the filler cap and install the filler cap.
Start the engine and allow the oil to warm. Check the engine for leaks.
Run the engine. Check the "ENGINE RUNNING" side of dipstick (1) while the engine is running. Maintain the oil level between the "ADD" mark and the "FULL" mark. If necessary, add oil .
Stop the engine. Close the left side rear engine compartment access door, if the machine is equipped with engine compartment access doors.