BRACKET AS 2311690 - Caterpillar

Illustration 1. 3W-6125 Support Assembly (Bottom View).Procedure To Install Cushion Stops On Standard Drawbar
1. If the drawbar is off the machine, locate blocks (1) 65 mm (2.6 in) inboard and parallel to the outer support plate. See Illustration 1, Dimension (A)2. If the drawbar is on the machine, swing the drawbar to the outside hole and pin it in place. Attach stop (2) to block (1). Place the stop against the outer side of the drawbar. Tack weld in place and repeat the procedure on the other side. Remove stop (2) before welding the blocks in place to prevent damage to the rubber on the stop.3. Weld blocks (1) to the support assembly. The weld should be a 10 mm (.4 in) fillet weld with a minimum of 1.5 mm (.06 in) penetration. Do not exceed a 12 mm (.5 in) weld fillet to prevent interference with the cushion stop.4. Install stops (2) using bolts (3) and washers (4).Procedure To Install Cushion Stops On Three-Point Hitch
Illustration 2. Part of 3W-7235 Support Assembly on three-point hitch.1. Cut off the existing drawbar stops (C). 2. See Illustration 2 and the chart to locate the mounting holes on both sides of the 3W-7235 Support Assembly.3. Drill and tap four holes (B).4. Install stop (2) using bolts (3) and washers (4).