BRACKET AS 2337807 - Caterpillar

Illustration 1.
Typical view of demountable rim group. Wheel Bearing Adjustment Procedure For The Rear Wheels Of 784B Tractors And 785, 785B Off-Highway Trucks
The following procedure must be used to adjust wheel bearings in the 142-5136, 142-5135, 140-7626, 0R-9034 Rear Wheel Groups (groups are not serviced), and 144-3854 Service Wheel Arrangement.
1. Thoroughly clean the tapped holes (6) in the end of the spindle to receive the retainer bolts (3).2. With bearing assemblies (1) already in position inside retainer (2) install retainer (2) using five clean 1D-4610 Retainer Bolts (3). Install the retainer bolts in equally spaced hole positions. Tighten opposite bolts evenly around the bolt circle to 200 N m (150 lb ft). 3. Remove any lifting brackets or supports from under the wheel station. 4. Release the brakes. Refer to the "Towing" section in the Systems Operation, Testing and Adjusting (Air Systems and Brakes) module.5. Turn the wheel two complete revolutions.6. Retighten the retainer bolts (3) to 200 N m (150 lb ft) using the same tightening sequence. Turn the wheel two complete revolutions.7. Loosen all retainer bolts (3) in the same sequence by 120 degrees (two bolt head flats). Turn the wheel two complete revolutions.8. Tighten opposite retainer bolts (3) evenly to 80 N m (60 lb ft). Rotate the wheel two complete revolutions.9. Repeat Step 7 until no further movement of the retainer bolts (3) occurs when a torque of 80 N m (60 lb ft) is applied.10. Use a depth micrometer and measure the average distance between the outside face of the retainer (2) to the end of the spindle. Measure two holes directly opposite each other and average the measurements. Refer to Illustration 3. Record Dimension B. In addition to the hole pattern in the retaining plate for the retaining bolts, there are two holes which may be used to make the measurement indicated in Step 10.
Illustration 2.
Typical cross-sectional view of partially assembled wheel group.
Illustration 3.
View X. Gap = (A-B) 11. Use an outside micrometer and measure the thickness of the retainer (2) at the bolt holes. Refer to Illustration 3. Record Dimension A. 12. Calculate the average gap between the end of the spindle and inside face of the retainer by subtracting dimension recorded in Step 10 from dimension recorded in Step 11. If the two measurements differ by more than 0.13 mm (0.005 in), DO NOT CONTINUE, restart adjustment procedure beginning with Step 2. If the two measurements again differ by more than 0.13 mm (0.005 in), disassemble and check for any interference that would prevent correct seating of the wheel bearings. Record the average of the measurements and remove the retainer (2). Refer to Illustration 3. 13. Select and install the required shim pack (4).a. Shim pack required without screen assembly (5). Determine the required shim thickness, add 0.178 +