BRACKET AS 2367755 - Caterpillar

Typical Example19. Disconnect the fuel return hose assembly from fitting (34). Put a cap on fitting (34).
Typical Example20. Loosen two hose clamps and remove hose (35) from the transmission oil cooler.21. Loosen the hose clamps and disconnect hoses (36) and (37) from the valve assemblies.
Typical Example22. Loosen two hose clamps and disconnect hose (38) from tube (39).23. Disconnect hose assembly (40) from the brake oil cooler.
Typical Example24. Disconnect hose assembly (41) from tube assembly (42).
Typical Example25. Disconnect hose assembly (43) from the brake oil cooler.26. Remove bolt and clamp (44) and disconnect hose assembly (45) from the brake oil cooler.27. Remove the bolt and clamp that fastens hose assembly (43) to the front of the torque converter housing.
Typical Example28. Remove hose assembly (47) from elbow (48) and diverter valve (46). Loosen the hose clamps and remove hose (49).
Typical Example29. Disconnect hose assembly (50) from elbow (48).
Typical Example30. Disconnect hose assembly (51) from the torque converter inlet relief valve.31. Disconnect hose assemblies (52) and (53) from the torque converter housing.32. Disconnect hose assemblies (55) and (56) from torque converter oil pump (57).33. Disconnect hose assembly (54) from the parking brake release section of pump (57). 34. Disconnect hose (59) from the spacer block.36. Disconnect hose (58) and the spacer block from pump (57).37. Disconnect hose assemblies (60) and (61) from the brake cooling section of pump (57). 37. Disconnect hose assemblies (63), (64) and (65) from the lockup clutch valve.38. Disconnect hose assembly (65) from the torque converter housing.39. Remove main drive shaft guard (62).
Typical Example40. Remove fitting (67) and loosen the collar at the rear of yoke assembly (68), (part of main drive shaft).41. Remove the bolts that hold spider and bearing assembly (69) to the torque converter yoke.42. Slide yoke assembly (68) away from the torque converter yoke.
Typical Example43. Remove the bolts that hold drive shaft guard (71). Remove drive shaft guard (71).44. Remove bolts (72) and disconnect drive shaft (70), (auxiliary drive shaft).
Typical Example45. Remove the washers, bolts and nuts (74) that hold caps (73) in position. Remove caps (73) from both of the rear engine supports.
Typical Example46. If equipped, remove strap (75) from the engine front support.
Typical Example47. Remove the nuts, washers, and bolts (77). Remove top cushions (76) from both sides of engine front support (78).
Typical Example48. Fasten a hoist to the engine. Remove the engine and torque converter, from the truck. The weight of the engine and torque converter is approximately 8,375 kg (18,500 lb). The following steps are for installing the engine and torque converter
Typical Example49. Fasten a hoist to the engine. Put lower cushions (80) in position in engine front support (79). Put the engine and torque converter in position in the truck. Be sure mounting surfaces are free from paint or dirt.
Typical Example50. Install sleeve (81) on both sides of the engine front support. Install upper cushions (76). Install bolts (77), washers and nuts. The torque for bolts (77) is 1800 200 N m (1325 150 lb ft).51.