BRACKET AS 2390283 - Caterpillar

To prevent personal injury always lower all equipment, stop the engine, set the parking brake and block or restrain the machine before servicing it, unless otherwise specified. Read and understand all warning and caution information provided on the machine. Follow servicing instructions carefully.Do not attempt adjustments while the machine is moving or the engine is running.Do not allow unauthorized personnel on the machine while it is being serviced. Wear a hard hat, protective glasses and protective shoes as the job requires.Use the proper tools. Repair or replace broken or damaged equipment.Operate the engine only in a well ventilated area.When operating the engine in a closed area, vent the exhaust to the outside. Always inspect the cooling system with the engine stopped and cool. Remove the radiator cap slowly to relieve pressure. Steam can cause personal injury.Cooling system conditioner contains alkali, avoid contact with the skin and eyes.Store all oily rags and other combustible material in a safe place.Do not smoke when observing the battery electrolyte level. Batteries give off flammable fumes.Do not allow the electrolyte solution to contact the skin or eyes. Electrolyte solution is an acid. Engage the parking brake, block the tires and attach a warning tag to the controls while servicing the machine. Connect frames with the antipivot link before servicing the machine center area. Turn the disconnect switch OFF and remove the key before servicing the electrical system. Use caution when removing the radiator cap, drain plugs, grease fittings or pressure taps.To avoid possible weakening of the ROPS (Roll-Over Protective Structure), consult a Caterpillar dealer before altering the ROPS in any way. The protection offered by the ROPS will be impaired if it has been subjected to structural damage or has been involved in an overturn incident.When using pressure air, wear protective glasses and protective clothing. Maximum air pressure must be below 30 psi (205 kPa).Diesel fuel and all lubricants are flammable. Do not weld on pipes or tubes that contain oil. Clean them thoroughly with nonflammable solvent before welding.Do not smoke when refueling.Loose or damaged lines, tubes, and hoses, which leak, can cause fire. **Do not bend or strike high pressure lines. Do not install bent or damaged lines, tubes, and hoses.*Inspect all lines, tubes, and hoses, carefully. Tighten all connections to the recommended torque. Make sure that all clamps, guards, and heat shields, are installed correctly to prevent vibration, rubbing against other parts, or excessive heat during operation.*Shields, which protect hot exhaust components from oil or fuel spray, in the event of a line, tube, or seal failure, must be installed correctly.Do not attempt any repairs you do not understand. If the engine is not running, do not release the emergency or parking brake systems, unless the machine is blocked or restrained. Use a self-attaching air chuck and stand behind the tread when inflating tires. Whenever draining a lubricant, extreme caution should be used; the lubricant may be hot and can cause personal injury. Hot hydraulic oil can cause personal injury.