BRACKET 2429392 - Caterpillar

Installation Procedure
Table 1
Required Tools    
Tool     Part Number     Part Description     Qty    
A     9U-6238     Guide Bolt     2    
B     8T-3052     Degree Wheel     1    
Thoroughly clean the top of the cylinder block and the bottom of the cylinder head. Ensure that there is no debris in the cylinder bores.
Illustration 1 g00550165
Place cylinder head gasket (3) on dowels (4) on top of the cylinder block. The cylinder head gasket (3) is stamped "FRONT TOP". Do not use any sealant or compound on the cylinder head gasket.
Install Tool (A) in positions 15 and 20 in the cylinder block. Refer to Illustration 4.
Illustration 2 g00550163
Typical example
Attach a suitable lifting device to cylinder head (2) .
Place cylinder head (2) on the cylinder block. Ensure that the cylinder head is positioned on dowels (4) and that cylinder head gasket (3) is positioned correctly.
Remove Tool (A) .
Illustration 3 g00550160
Typical example
Lubricate cylinder head bolts (1) with clean engine oil.
Illustration 4 g00550162
Gradually tighten all of the bolts (1 through 22) in a numerical sequence to a torque of 110 N m (80 lb ft).
Tighten all of the bolts (1 through 22) again in a numerical sequence to a torque of 110 N m (80 lb ft).
Place an index mark on the bolts and use Tool (B) in order to further tighten the bolts. Refer to illustration 4.
Turn the short bolts that are marked with an "S" for an additional 150 degrees (2.5 flats).
Turn the medium length bolts that are marked with an "M" for an additional 180 degrees (3.0 flats).
Turn the long bolts that are marked with an "L" for an additional 210 degrees (3.5 flats).End By:
Install the rocker shaft assembly. Refer to Disassembly and Assembly, "Rocker Arm and Shaft - Install".
Install the water outlet manifold. Refer to Disassembly and Assembly, "Water Outlet Manifold - Install".
Install the fuel filter base. Refer to Disassembly and Assembly, "Fuel Filter Base - Remove and Install".
Install the fuel injection nozzles. Refer to Disassembly and Assembly, "Fuel Injection Nozzles - Install".
Install the exhaust manifold. Refer to Disassembly and Assembly, "Exhaust Manifold - Remove and Install".
Install the inlet manifold. Refer to Disassembly and Assembly, "Air inlet Manifold -Install".
Fill the coolant system. If the engine uses Extended Life Coolant (ELC), refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change". If the engine uses Diesel Engine Antifreeze/Coolant (DEAC), refer to Operation and Maintenance Manual, "Cooling System Coolant (DEAC) - Change".
Connect the electrical connections at the battery.