BRACKET AS 2667745 - Caterpillar

Push one 8T-5400 Connector As (H) through the hole in the cab floor plate as shown in Illustration 5 and orient the 45 degree connection facing towards the back of the machine.
Connect the down facing connection of 8T-5400 Connector As (H) to 144-0195 Hose (289 5 mm (11 0.2 inch)) (G) under the floor plate.
Connect 144-0195 Hose (1678 10 mm (66.06286 0.39370 inch)) (J) onto 8T-5400 Connector As (H) and route hose (J ) towards back of machine.
Route Hose (J) up the inside of the rear plate. Install one more 8T-5400 Connector As (H) through the rear plate after connecting the 45 degree angle to Hose (J) .
Secure Hoses (J), (E), and (F) along the route between 416-0021 Washer Pump As (D) and where last 8T-5400 Connector As (H) passes through the rear upper plate using 3S-2093 Cable Straps (K) . Refer to Illustrations 4 and 5 for placement.Install Rear Wiper Motor
Illustration 6 g03871366
(1) 152-6641 Window Wiper Arm As (2) Shaft washer (3) Shaft Nut (4) Wiper supply hose (5) Cap Nut (6) lock washer (7) Lock Nut (8) 348-8786 Window Wiper Motor Gp
Install 348-8786 Window Wiper Motor Gp (8) by pushing the mounting stud and wiper motor shaft through the mounting holes in the rear plate.
Secure 348-8786 Window Wiper Motor Gp (8) using shaft washer (2) with shaft nut (3) and lock washer (6) with cap nut (5). Refer to illustration 6 for clarification.
Tighten shaft nut (3) to 9 1 N m (80 9 lb in). Tighten cap nut (5) to 7.5 5 N m (66 44 lb in).
Install 152-6641 Window Wiper Arm As (1 ) onto wiper motor (8) shaft using supplied nut (7). Tighten Nut (7) to 21 1 N m (186 9 lb in).Note: Wait at least 30 minutes and a maximum of 4 hours and reapply the torque to nut (7) 21 1 N m (186 9 lb in).
Connect wiper supply hose (4) to 8T-5400 Connector As (H) installed previously.
Install 8Y-4615 Wiper Blade (not shown) to the mounting hook on the end of 152-6641 Window Wiper Arm As (1) Connecting the Wiper Switch
Illustration 7 g03871479
Remove the fourth 165-0311 Plug from operator console located on the right-hand side of the cab. Refer to Illustration 7.
Locate the fourth harness receptacle from the end of the existing wiring harness found under the switch plugs on the operators console and pull up the receptacle through the hole left from removing the plug-in Step 1.
Install one 350-1229 Rocker Switch (1) onto the fourth harness receptacle.
Mount Switch (1) back into the fourth hole in the console.Reroute Harness and Connect to Rear Wiper Motor
Illustration 8 g03871715
(A) view of cab with wiper motor (B) View of cab before wiper motor (1) 374-7465 Seal Cap (2) existing harness (3) Wiper motor (4) 3S-2093 Cable Straps
Remove 374-7465 Seal Cap