BRACKET 2683297 - Caterpillar

Fuel leaked or spilled onto hot surfaces or electrical components can cause a fire. To prevent possible injury, turn the start switch OFF when changing fuel filters or water separator elements. Clean up fuel spills immediately.
Do not allow dirt to enter the fuel system. Thoroughly clean the area around a fuel system component that will be disconnected. Fit a suitable cover over any disconnected fuel system components.
1. Stop the engine. Turn the ignition/start switch OFF or disconnect the battery. Shut off the fuel supply valve (if equipped).2. Remove and discard the used fuel filter.3. Clean the gasket sealing surface of the fuel filter base. Make sure all of the old gasket is removed.4. Apply clean diesel fuel to the new fuel filter gasket.
Do NOT fill the fuel filters with fuel before installing them. The fuel would not be filtered and could be contaminated. Contaminated fuel will cause accelerated wear to fuel system parts.
5. Install the new fuel filter onto the fuel filter base until the gasket contacts the base. Tighten the fuel filter one full turn (360 degrees) more by hand. Do not overtighten.6. Open the fuel supply valve. Prime the fuel system. Start the engine and inspect for fuel leaks.
Do not crank the engine continuously for more than 30 seconds. Allow the starting motor to cool for two minutes before cranking again.
There should be enough residual fuel in the cylinder head to start the engine. If the engine starts and then stops, crank the engine for no more than 30 seconds, then allow the starting motor the cool for two minutes. Repeat this cranking and cooling cycle until the engine starts and operates.