BRACKET GP-MOUNTING 2750999 - Caterpillar

Starting With the Starting Aid Switch (If Equipped)
Personal injury or property damage can result from alcohol or starting fluids.Alcohol or starting fluids are highly flammable and toxic and if improperly stored could result in injury or property damage.
Excessive starting fluid can cause piston and ring damage.Use starting fluid for cold starting purposes only.Do not use excessive starting fluid during starting or after the engine is running.
The optional ether starting aid which is on the control panel is the only system that is recommended for the injection of starting fluid.
Perform the procedures that are described in this Operation and Maintenance Manual, "Before Starting Engine".
Press the "RUN" key.
Ether will automatically be injected if the following conditions are met:
The Starting Aid switch is in the AUTOMATIC position.
The jacket water coolant temperature is less than 0 °C (32 °F).
More injections may be necessary to start the engine. More injections may also be necessary to achieve low idle. If more injections are necessary, toggle the Starting Aid switch to the MANUAL position. For more injections, the jacket water coolant temperature must be less than 10 °C (50 °F).Note: The Starting Aid switch is a momentary switch. To stop the injection, release the Starting Aid switch.Selective Cylinder Cutout (SCC) (If Equipped)
SCC is used to control combustion during cold start, and low load conditions by only activating 3 cylinders during these conditions. SCC helps maintain consistent power and reduction in white smoke.