BRACKET AS 2778716 - Caterpillar

Illustration 1 g00585386
Install the return spring (15) into the solenoid (2) .
Illustration 2 g00585389
Install the rollers (14) and the retainer (13) into the drive end housing (4) .
Illustration 3 g00585386
Put the idler gear (12) and the armature reduction gear (11) onto the drive end housing (4) .
Illustration 4 g00585348
Put the steel ball (10) into the overrunning clutch (9) .
Illustration 5 g00585337
Put the overrunning clutch (9) into the drive end housing (4) .
Illustration 6 g00585327
Put the drive end housing (4) on the solenoid (2) and install the screws. Tighten the screws to a torque of 0.6 N m (5.3 lb in) to 0.9 N m (7.9 lb in).
Illustration 7 g00585312
Put the armature (8) into the case of the starting motor (3) .
Illustration 8 g00585753
Put the brush holder (7) in position over the commutator. Put the positive brushes, which are connected to motor case (3) into the positive holders. The positive holder is separated from the plate by an insulator. Put the negative brushes into the negative uninsulated holders. The negative brushes are connected to brush holder (7) .
Illustration 9 g00585304
Make sure that the wires for the positive brush lead are not grounded. Put the brush springs (5) on top of the brushes (6) with a pair of long nose pliers. Make sure that the brush holder (7) and the commutator are free of oil.
Illustration 10 g00586185
If the motor case has an end frame (16), install the end frame onto the case of the starting motor. Tab (22) that is on the end frame must line up with the lead wire grommet (23) that is on the case of the starting motor.
Illustration 11 g00586190
Put the case of the starting motor (3) in position onto the solenoid (2). Engage the TAB (22) on the case of the starting motor with the notch in the solenoid. Install the through bolts and tighten the through bolts to a torque of 1.5 N m (13 lb in) to 2.4 N m (21 lb in).
Illustration 12 g00585273
Connect the lead wire (1) to the motor terminal of the solenoid (2) .Install the starting motor onto the machine.