BRACKET 2F7653 - Caterpillar

Table 1
Lubricant Viscosities for Ambient Temperatures    
Compartment or System    Oil Type and Classification    Oil Viscosities    °C    °F    
Min Max    Min    Max    
Engine Crankcase (1) (2)     Cat DEO Multigrade
Cat DEO SYN
Cat Arctic DEO SYN (3)
Cat ECF-1 (4)
API CG-4 Multigrade (5)     SAE 0W-20     -40     10     -40     50    
SAE 0W-30 -40     30     -40     86    
SAE 0W-40 -40     40     -40     104    
SAE 5W-30 -30     30     -22     86    
SAE 5W-40 -30     50     -22     122    
SAE 10W-30 -18     40     0     104    
SAE 10W-40 -18     50     0     122    
SAE 15W-40 -9.5     50     15     122    
Hydraulic System, Service Brake System, Transmission, Differentials and Final Drives (6)     Cat TDTO
Cat TDTO-TMS
Cat Arctic TDTO SYN
commercial TO-4     SAE 0W-20     -40     40     -40     104    
SAE 0W-30 -40 40     -40     104    
SAE 5W-30 -30 40     -22     104    
SAE 5W-40 -30 40     -22     104    
SAE 10W -20 40     -4     104    
SAE 30 10 50     50     122    
SAE 10W-30 -20 40     -4     104    
SAE 15W-40 -15 50     5     122    
Cat TDTO-TMS (7) -20 50     -4     122    
( 1 ) Supplemental heat is recommended for cold soaked starts below the minimum ambient temperature. Supplemental heat may be required for cold soaked starts that are above the minimum temperature that is stated, depending on the parasitic load and other factors. Cold soaked starts occur when the engine has not been operated for a period of time, allowing the oil to become more viscous due to cooler ambient temperatures.
( 2 ) API CF oils are not recommended for Caterpillar 3500 Series and smaller Direct Injection (DI) diesel engines. API CF-4 oils are not recommended for Caterpillar machine diesel engines.
( 3 ) Cat Arctic DEO SYN is an SAE 0W-30 viscosity grade oil.
( 4 ) API CI-4, API CI-4 PLUS, and API CH-4 oils are acceptable if the requirements of Caterpillar's ECF-1 (Engine Crankcase Fluid specification - 1) are met. API CI-4, API CI-4 PLUS, and API CH-4 oils that have not met the requirements of Caterpillar's ECF-1 specification may cause reduced engine life.
( 5 ) API CG-4 oils are acceptable for use in all Caterpillar machine diesel engines. When API CG-4 oils are used, the oil change interval should not exceed 250 hours. API CG-4 oils that also meet API CI-4, API CI-4 PLUS, or API CH-4 must also meet the requirements of the Caterpillar ECF-1 specification.
( 6 ) Refer to Operation and Maintenance Manual, "Capacities (Refill)" for the amount of 197-0017 Friction Modifier (Axle and Brake) that needs to be added to the center section of the front axle on your machine.
( 7 ) Cat TDTO-TMS (Transmission Multi-Season) (synthetic blend that