AVSPARE.COM
parts catalog

BRACKET A. 2H9555 - Caterpillar



2H9555 BRACKET A. Caterpillar parts BRACKET
Rating:
71
Alternative (cross code) number:
CA2H9555
2H-9555
2H9555
Caterpillar 2H9555 BRACKET A.
Weight: 0.03 pounds 0 kg.

Buy BRACKET A. 2H9555 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

Which Generate This Code:This diagnostic code is associated with the solenoid for the Pump for the Right Drive (Reverse). The FMI 13 means that the ECM has determined that the solenoid needs calibration. Once the calibration for the solenoid valve has been performed successfully, this diagnostic code will disappear. This failure is active on a new ECM.Possible causes of this diagnostic code are listed below:
The ECM has been replaced or new software has been installed.
The calibration procedure has failed.System Response:The deadband in the control lever may be excessive. The operation of the control lever may be jerky.Note: Ensure that you have repaired any condition that would cause other active diagnostic codes that are related to this solenoid. CID 1706 FMI 03, FMI 05 and FMI 06 for example, this is not active when the cid 1706 fmi 13 is active. If the other diagnostic codes are active, troubleshoot those codes first. Then perform this procedure.Note: Ensure that the diagnostic code of CID 1706 FMI 13 is active before performing this procedure.Test Step 1. CHECK THE CALIBRATION
Perform the calibration procedure. Refer to the Testing and Adjusting section of this Service Manual for the correct procedure. Verify that the procedure to calibrate the ECM has successfully completed. Verify that the calibration for the ECM is complete. In order to clear the diagnostic code fmi 13 verify that no warnings exist
Observe the status of the CID 1706 FMI 13.Expected Result:The CID 1706 FMI 13 is active.Results:
YES - The CID 1706 FMI 13 is active. The diagnostic code has not been corrected. Verify that the correct software has been flashed into the ECM, or that the correct ECM is installed on the machine. Then repeat the calibration.Repair: Prior to replacing an ECM, contact your dealership and consult with a Technical Communicator for possible consultation Caterpillar. This consultation may greatly reduce repair time. If the ECM requires replacement, refer to Testing and Adjusting, "Electronic Control Module (ECM) - Replace".STOP
NO - The CID 1706 FMI 13 is not active. The calibration corrected the condition that caused the diagnostic code. Repair: Resume normal operation.STOP


Parts bracket Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.