BRACKET AS 3005370 - Caterpillar

Steering clutch and brake control linkage adjustments should be made only with the engine OFF. Accidental disengagement of the parking brake while the engine is running could cause sudden machine movement and personal injury.
Torque for the four bolts that fasten the steering clutch and brake control valve to the housing ... 108 7 N m (78 5 lb.ft.)Torque for all 3/8 in. locknuts (jam nuts) that hold the rod ends in place on the rod ... 14 4 N m (10 3 lb.ft.)Torque for all 1/2 in. locknuts (jam nuts) that hold the rod ends in place on the rod ... 45 7 N m (33 5 lb.ft.)Torque for bolt (5) that holds the foot brake pedal ... 135 15 N m (100 11 lb.ft.)(A) Assembled length of rod assembly ... 493 2 mm (19.41 .08 in.)(B) Assembled length of rod assembly ... 493 2 mm (19.41 .08 in.)(C) Assembled length of rod assembly ... 361 2 mm (14.21 .08 in.)(D) Assembled length of rod assembly ... 88 2 mm (3.46 .08 in.)(E) Assembled length of rod assembly ... 714 2 mm (28.11 .08 in.)(F) Assembled length of rod assembly ... 400 3 mm (15.75 .12 in.)(G) Assembled length of rod assembly ... 541 2 mm (21.30 .08 in.)(H) Assembled length of rod assembly ... 520 2 mm (20.47 .08 in.)(I) Assembled length of rod assembly ... 323. 2 mm (12.72 .08 in.)Procedure For Adjustment Of Steering Clutch And Brake Linkage
1. Install rod assemblies (A) and (B) after they have been adjusted to the correct length. This length is measured in a straight line between the centerlines of the rod end mounting holes.2. Make sure the springs are installed on the levers of the steering clutch control valve.3. With steering clutch levers (1) and (2) against bumper (3) install rod assemblies (G) and (H).4. Make adjustments to rod assemblies (G) and (H) so there is a clearance between steering clutch levers (1) and (2) and bumpers (3) of ... 1.0 + 1.0 - 0.5 mm (.04 + .04 - .02 in.)Procedure For Adjustment Of Brake Pedal Linkage
Parking brake and transmission lock lever (4) must be in the OFF position (UP) when making adjustments to the linkage. Adjustments for the brake pedal linkage to be done before those for the parking linkage and transmission lock.1. Install rod assemblies (D), (F) and (I) after they have been adjusted the correct length. This length is measured in a straight line between the centerlines of the rod end mounting holes.2. Make sure the spring is in place on the lever on the steering clutch control valve.3. Install rod assembly (I) and make an adjustment to the length of rod assembly (I) to get clearance (J) of 0.25 0.25 mm (.010