BRACKET AS 3049457 - Caterpillar

Table 1
4: VIEW/PRINT REPORT        
5: CAL PAYLOAD        Then press the "4" key for the "4: ENTER CAL WT" option.
Table 2
3: ENTER CARRYBK WT        
4: ENTER CAL WT        A two line menu is displayed after the operator selects the "4: ENTER CAL WT" option.
Table 3
0: ENTER CAL WT        
1: EXIT NO CHANGE        Press the "0" key in order to proceed with the calibration. To exit this menu, press the "1" key. The operator can return to the calibration menu by pressing the "OK" key. If the operator chooses to proceed with the change, the system prompts the operator to enter a new calibration weight:
Table 4
ENTER CAL WT        
X.X TON        In this case, the operator has entered a new calibration weight of 28.6 tons. To accept the new value, the operator must press the "OK" key.
Table 5
ENTER CAL WT        
28.6 TON        The operator uses the standard method of entering data for the loader payload system to input the new calibration weight. The new value of the calibration weight is used for all future calculations of the weight of the bucket. Note: The value of the present calibration weight and the "date/time" of the last modification can be viewed on the message center. Refer to the Systems Operation, "Calibration" "Check Calibration Information" section of this manual for details about viewing data.