BRACKET-STRIKER 3153890 - Caterpillar

Illustration 1 g01022142
(1) Install the taperlock studs into the front housing to following depth. ... 28.5 1.5 mm (1.12 0.06 inch)Note: Remove all old sealant and gasket material after disassembling the front housing. The rear face of the front housing and the front face of the cylinder block must be free of oil, fuel, water, dirt and any other contaminants during assembly. (2) The cylinder block gasket for the front housing must be trimmed after assembly. Trim the excess cylinder block gasket from the bottom of the front housing after assembly. (3) Apply a layer of 4C-9612 Silicone Sealant between the cylinder block, the front housing, and the oil pan.