BRACKET 3364757 - Caterpillar

To maintain proper machine control and effective hydrostatic braking on downhill slopes over 6%, this machine must be operated in Low Range (L). Failure to follow these instructions could result in an overspeed condition, loss of control and/or sudden stopping by the secondary (emergency) braking system which could cause serious injury or death.
Note any needed repairs during machine operation. Report any needed repairs.Carry attachments approximately 40 cm (15 inches) above ground level. Do not go close to the edge of a cliff, an excavation, or an overhang.If the machine begins to sideslip downward on a grade, immediately remove the load and turn the machine downhill. Avoid any conditions that can lead to tipping the machine. The machine can tip when you work on hills, on banks and on slopes. Also, the machine can tip when you cross ditches, ridges or other unexpected obstructions.Avoid operating the machine across the slope. When possible, operate the machine up the slopes and down the slopes. Maintain control of the machine. Do not overload the machine beyond the machine capacity.Be sure that the hitches and the towing devices are adequate.Only connect the trailing equipment to a drawbar or to a hitch.Never straddle a wire cable. Never allow other personnel to straddle a wire cable.Before you maneuver the machine, make sure that no personnel are between the machine and the trailing equipment. Block up the hitch of the trailing equipment in order to align the hitch with the drawbar. Maneuver the machine. Connect the machine to the trailing equipment. Know the maximum dimensions of your machine.