BRACKET AS 3410832 - Caterpillar

Failure to comply to the rated load can cause possible personal injury or property damage. Review the rated load of a particular work tool before performing any operation. Make adjustments to the rated load as necessary for non-standard configurations.
Note: Rated loads are based upon a standard machine with the following conditions:
lubricants
full fuel tank
Canopy
75 kg (165 lb) operatorRated loads will vary with different work tools. Consult your Caterpillar dealer regarding the rated load for specific work tools. Note: Rated loads should be used as a guide. Work tools, uneven ground conditions, soft ground conditions, or poor ground conditions have effects on rated loads. The operator is responsible for being aware of these effects.Special hazards (toxic gases, ground conditions, etc.) require special precautions. The operator must determine whether special hazards exist in each application. The operator shall perform the appropriate steps in order to eliminate the hazard. The operator shall perform the appropriate steps in order to reduce the hazard.For North American applications, the rated operating load is defined by " SAE J1097 1988". For European applications, the rated operating load is defined by "ISO 10567 1992". The rated operating load is defined as the lower value of 75% of the static tipping capacity or 87% of the hydraulic lift capacity.Note: In European countries, regulations require a load sensing indicator and a boom lowering control device if more than 1000 kg (2200 lb) is lifted during object handling applications. Regulations also require a load sensing indicator and a boom lowering control device if a moment that is greater than 40000 N m (29500 lb ft) is created during object handling applications.Note: European regulations require the machine to be equipped with a mechanism that locks the dozer blade into position if the dozer blade is used to increase stability. If a mechanism that locks the dozer blade into position is not installed, use the values that are given in the tables for the machine when the blade is up. If a mechanism that locks the dozer blade into position is installed, use the values that are given in the tables for the machine when the blade is down.Symbols Found in the Lifting Capacity Charts
Below are symbols that are commonly found on lifting capacity charts for track excavators.Note: Depending on the machine configuration, some symbols may not be used.
Reach from swing center
Load hook height
Authorized lift capacity with horizontal boom
Blade in front
With or without blade, 90° to front
Blade UP
Blade DOWN
Undercarriage extended
Undercarriage retractedStandard Counterweight
Illustration 1 g03385048
Short Stick
Illustration 2 g03385049
Long Stick
Additional Counterweight
Illustration 3 g03385051
Short Stick with Additional Counterweight
Illustration 4 g03385052
Long Stick with Additional Counterweight