BRACKET AS 3433032 - Caterpillar

Removal Procedure
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Thoroughly clean the area around the valve mechanism cover in order to prevent the entry of foreign matter into the cylinder and valve mechanism. After the valve mechanism cover is removed, put a clean cover over the opening in order to prevent the entry of airborne dust and abrasive particles.
Illustration 1 g01953184
Remove bolt (2) and the washer that holds breather assembly (1) in place.
Remove breather assembly (1), the fumes disposal hose, and the O-ring seal as a unit. Note: Ensure that all harness assemblies are disconnected before removal of the valve mechanism cover.
Remove bolts (4) and the lockwashers. Remove valve mechanism cover (3) and the integral seal. Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 5H-2471 Adhesive -
Illustration 2 g01953184
Illustration 3 g01953198
G3304B
Illustration 4 g01953199
G3306B
Apply Tooling (A) on the face of valve mechanism cover (3). Install the integral seal, valve mechanism cover (3), the lockwashers, and bolts (4).
Tighten the bolts for the G3304B Engine in a numerical sequence to a torque of 11 3 N m (95 27 lb in). Tighten the bolts for the G3306B Engine in a numerical sequence to a torque of 16 3 N m (140 27 lb in). Note: Ensure that all harness assemblies are connected.
Install the O-ring seal, the fumes disposal hose, and breather assembly (1). Install the washer and bolt (2). Tighten bolt (2) to a torque of 14 3 N m (125 27 lb in).