BRACKET AS 3499163 - Caterpillar

Table 1
Typical Configuration Parameters
Parameter Programmability
Air shutoff (ON/OFF) Yes
CAT Datalink #2 identifier Yes
Crank duration Yes
Crank terminate speed Yes
Cold mode cylinder cutout Yes
Cooldown speed Yes
ECM serial number No
Engine acceleration rate Yes
Engine cooldown duration Yes
Engine cooling system configuration (1) Yes
Engine prelube duration Yes
Engine rated speed Software dependent
Engine rotation Software dependent
Engine serial number Yes
Equipment ID Yes
Ether control (ON/OFF) Yes
Fuel correction factor Yes
Fuel ratio control offset Yes
Low idle speed Yes
Maximum number of crank cycles Yes
Personality Module Part Number Software dependent
Personality module release date Software dependent
Rated fuel position Yes
Total fuel Yes
Total hours Yes
Total tattletale No
(1) Jacket water aftercooling or separate circuit aftercoolingThe following parameters are programmed at the factory to “0”:
"Crank Duration"
"Maximum Number Of Crank Cycles"The “0” settings prevent the Electronic Control Module (ECM) from engaging the starting motors. The settings must be reprogrammed before the engine will crank.Ensure that the "Air Shutoff" and the "Ether Control" parameters are "Enabled/ON" (if equipped) . If the engine does not have these options, ensure that these two parameters are "DISABLED/OFF".If the engine is equipped with Prelube, the "Engine Prelube Duration" must be programmed to a value that is greater than “0” seconds. Otherwise, the prelube pump will not cycle. If the engine is not equipped with Prelube, the parameter must be programmed to “0”.The engine has separate circuit aftercooling. The correct configuration of the aftercooling system must be programmed.Engine Serial NumberThe engine serial number should be programmed in order to match the engine serial number that is stamped on the Engine Information Plate.Note: The engine serial number is not programmed on a new ECM.Refer to Troubleshooting for detailed programming instructions.Note: A new ECM date/time clock is programmed so that most of the configuration parameters and monitoring parameters may be reprogrammed. These parameters may be changed from the default setting of the factory in the first 100 hours. These changes may be made without a password. After 100 hours, a password will be required for certain parameters.